VoiceInterop AudioMate AM360r User Manual - page 4
WWW.VOICEINTEROP.COM
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300
4
AM360r User Manual
revised 2008.07.11 for
Hardware Rev. A
Firmware Version 1.00.20
Front Panel Connections
There are no connections to the front panel of the AudioMate 360r.
Front Panel Controls
There are no controls on the front panel of the AudioMate 360r.
Rear Panel
Rear Panel Indicators
LAN Port
— The LAN jack has two built-in lamps: a solid green one indicating that an
electrical link has been established, the other flashing green indicating packet activity.
Rear Panel Connections
4-Wire E&M
— This RJ-45 E&M port provides a balanced 600 ohm transformer-coupled
audio connection to popular 2-way radios. There are multiple standards for connections to
a radio using the RJ-45. The electrical specifications and pin assignments for the AudioMate
360r E&M connector are given in Appendix A, along with interface examples. Be careful not
to connect an Ethernet cable to the E&M port, as they both employ RJ-45 jacks.
Analog
— Allows connection of single-ended audio and control signals from popular 2-way
radios via a screw terminal plug. This plug accepts stranded or solid wire. All signaling is
single ended, referenced to ground. The pin assignments and electrical specifications for the
AudioMate 360r Analog connector are given in Appendix A, along with interface examples.
LAN
— Standard 10/100BaseT Ethernet port with pin-outs following the AT&T T568B
specification. A standard Category 5 LAN cable connects it to an Ethernet switch. Be careful
not to connect the E&M cable to the LAN port, as they both employ RJ-45 jacks.
USB
— Allows a trained technician with a correctly setup computer to establish a direct
serial connection to the AudioMate 360r internal Diagnostic Console. Connects via a
standard USB A to Mini-B cable. The computer must have the Virtual Comm. Port driver from
FTDI (
ftdichip.com
) installed along with any standard terminal emulator. This port is
used for diagnostics; no voice parameters can be set.