Void KRYO K8 Owner's Manual - Kryo
Page 4
Kryo
Series Power Amplifiers
acoustics
Features
Rugged, touring grade chassis. E.I.A. Standard 19" (48.3cm) rack-mountable.
Ultra compact and lightweight 2u design.
Full PC control via optional Ethernet Module.
Super high frequency switch mode power supply.
Optional add on Modules extend operational capability.
Intelligent Clip limiters prevent harmful signals from damaging loudspeakers.
Parallel switch for channel linking.
Dual and Bridge modes for optimal load matching.
Balanced XLR inputs with Speakon and Binding Post outputs.
Complete protection against shorted outputs, mismatched loads, overheating and DC input/output.
Three year warranty and guarantee.
Precautions
Although your amplifier is protected from external faults, the following safety precautions are recommended:
1. The power switch must always be in the "off" position before connecting the amplifier to the mains
supply.
2. Do not change the position of the bridge mode switch unless the amplifier is switched off.
3. There are important differences between Dual, Parallel and Bridge modes. Please refer to page 8 for a
detailed description of the different modes and there uses.
4.Switch off the amplifier or turn down the inputs before connecting to the in/out XLR's.
5. Do not short the ground lead of an output cable to the input signal ground. This will form a ground loop
and may cause oscillations.
6. Do not operate the amplifier from AC mains in excess of 10% variation above or below the selected line
voltage, and only at the specified line frequency.