VOKERA Linea User instructions - page 3
Linea Max USERS
3
1.0
Operation
1.1
OFF Appliance will not activate if tap is turned on
or heating timers/controls are operated. Frost
protection is still active (see 1.3).
1.2
When the mode selector switch is selected (other
than OFF), with no demand for heating or hot
water the appliance will periodically light to
preheat the domestic hot water thermal store.
This is done to ensure that when a demand is
made for domestic hot water the appliance is not
cold, thereby reducing the wait for hot water, and
maximising hot water production.
If the appliance is unused for 19 hours the moto-
rised valve will operate one cycle, and the pump
will run for a period of 1 minute automatically
(provided the electrical supply to the appliance is
on). This will help prevent these components
becoming stuck if the appliance is not used for
long periods.
1.3
Frost Protection
The appliance will automatically ignite in central
heating mode if the appliance temperature drops
to approximately 5°C. The appliance will continue
to operate in central heating mode until it reaches
approximately 40°C.
2.0
Hot Water Only
Ensure electricity supply is on. (Status LED indi-
cating green).
2.1
With the boiler mode selector switch (6) turned to
(Fig. 2) the main burner will ignite electronically
whenever water is drawn from the tap.
2.2
Should the boiler fail to ignite the status LED will
flash red (this will be accompanied by an error
code showing at the the fault indicator (1) see 4.0
for list of error codes and remedies. For error
codes 01 to 03 and 05 to 08: turn the mode selec-
tor switch (6) to the reset position for a period of
at least 10 seconds then turn back to the original
position before drawing water again.
The appliance will re-attempt ignition. Should
lockout continue the appliance must be checked
by a competent person.
2.3
The maximum water flow rate to the tap is set at
a predetermined maximum delivery. The tempera-
ture of water at the tap can be varied by adjusting
the water flow rate at the tap up to the predeter-
mined maximum. The hot water temperature con-
trol knob (7) will govern the maximum temperatu-
re. Turning the knob clockwise increases the set-
ting, anticlockwise decreases setting. (Fig. 3)
When the appliance is being used in the hot
water mode the temperature/fault idicator (1)
indicates the approximate temperature of the hot
water leaving the appliance.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Filling loop
Filling/inlet valve
Gas Inlet