VolantexRC 757-7 User Manual - Landing

13 / 16

Disconnect the battery and remove it from the airplane. Then, turn off the transmitter. Allow the battery to cool

airplane to make sure nothing has become loose or damaged.

Make sure

that  the airplane initiates an ascending glide path. If necessary, add power to extend the glide path 

to reach control the glide path and altitude.

Continue to apply elevator until the mode l touches down at which time you should be holding full, or nearly full 

up elevator. This will cause the airplane to slow and settle to the ground.

CAUTION: If, during a rough landing, the propeller becomes jammed and cannot rotate, the battery and 

speed control will become very hot if you attempt to add power .

Immediately move the throttle down to stop the motor. If you fail to do this, the motor, speed control

and /or battery will be damaged.

l

Landing

After Flight

Charging Instruction

For charging the included lithium battery, you can only use the included charger set(balance charger and 

power supply), or a suitably compatible lithium battery charger. 

Charging the lithium battery using a none lithium battery compatible charger (such as a NiCd or NiMH 

battery charger), or even a different lithium battery charger with the incorrect settings, may result in damage 

to the battery or even fire resulting in property damage and/or personal injury.  

Follow below steps to charge the lithium battery with the included charger.

1. Plug the included balance charger to the power adaptor, then plug the power adaptor into a compatible 

AC outlet(depends on different contries and area) , then connect the power output lead to the receptacle 

on the side of the balance charger The power adapter and balance charger are powered on when the 

green color LED indicator is glowing.  

Lithium Battery

Balance Charger

Power 

Adaptor