Tm quick start guide quickstartguide smartcrystal™ pro booster qs v1.15 1126 model vpsp- 10 000
Installation & quick launch this section is independent of the rest of the manual. It is intended for advanced users who want to install the smartcrystal pro™ booster quickly without reading all the information in the manual. For optimal use of the product, it is recommended to follow the manual in ...
Configuring the projection position : « throw ratio » (tr) before any installation, it is important to ensure that the device is compatible with the configuration required. The "throw ratio" ("throw ratio ', tr) must satisfy the following requirements: throw ratio > 0,55.
Fixing & position • the smartcrystal™ pro booster shall be placed on a stable surface with 4 screws. • the smartcrystal ™ pro booster should be placed in front of the projector lens. There is a "projector side" serigraphy on the product that will indicate the correct direction. • the polarizer of th...
• connect the sync cable (bnc - bnc, bnc - 3 pin mini din) on the 3d sync output of the projector and the 3d sync connector on the smartcrystal pro™ booster • plug the power cable and the ethernet cable if necessary to smartcrystal pro™ booster • turn the switch to on starting • after switching on a...
