Vollara LAUNDRY PURE User Manual - page 6
6
INSTALLATION
2. Level and place the LaundryPure to the wall
marking where the two (2) keyholes are on each
side with a pencil. Drill two (2) holes in the wall
where marked and place two (2) supplied anchors
into the holes. Place the two (2) supplied screws
into anchors in the wall and tighten until almost
all the way. Move the keyholes of the LaundryPure
onto the screws and finish tightening to secure to
the wall.
4. Connect the end of the hose
from your cold water valve
to your LaundryPure’s INLET
connector (marked on front
of the LaundryPure).
6. Finally, connect the new
hose to the cold water inlet
on your washing machine.
5. Connect the new hose provided
with your LaundryPure to the
water OUTLET connector on
your LaundryPure unit.
Be sure rubber washers are properly inserted into hose connectors before installing hoses.
NOTE:
This appliance must be installed in a level, horizontal
configuration as shown.
Do not install the unit
vertically or at an angle. Failure to follow these
instructions may prevent the internal moisture sensor
from operating properly.
CAUTION:
When connecting or disconnecting hoses, hold the
threaded connector on your LaundryPure with pliers
while turning the hose connector. Failure to follow these
instructions may result in damage to your appliance.
CAUTION:
Hold with pliers
while installing
hose in order to
prevent fitting
from rotating.
1. Instructions to remove cover are located on page 9.
3. Reverse instructions located on page 10 to replace
cover
Hold with pliers
while installing
hose in order to
prevent fitting
from rotating.