Volt Big PAR36 Installation Instructions Manual - Install Luminaire to Stake
customersupport@voltlighting.com • 813.978.3700
Install/Replace Lamp
Reverse Step 2 - Step 3 to expose the lamp and replace it with correct
wattage and type marked on luminaire label. Reinstall shield with lens.
IMPORTANT: Halogen lamps must be protected from moisture and dust
at all times. Always re-install shield with lens when moved.
Clear away area in ground at wire-
way slot in top of stake. Align the
wireway slots on base and stake.
Lay luminaire pigtail into wireway
slots and screw luminaire into
stake. Tighten until snug to secure
base.
Install Luminaire to Stake
4
Luminaire
Base
Stake
Pigtail
Wireway Slot
Wire Connection
5
Strip two leads from luminaire pigtail. Using two wire connectors, sold
separately, connect leads from luminaire to main low voltage supply
cable leads.
Pigtail
Main Low Voltage
Supply Cable
Wire Connectors