Volvo 164 Instruction Book - page 52
Changing a wheel
Before the vehicle is jacked up, the hand-
brake should be applied and one of the
gears engaged.
Removal
1. Prise off the hub cap with the help of the
removal lever.
2. Loosen the wheel nuts 1/2-1 turn with
the help of the box spanner. All the nuts
have right-hand threads which are loose-
ned by turning them in an anti-clockwise
direction.
3. Insert the lifting arm of the jack in the
appropriate jack attachment of the wheel
to be changed. Jack up the side of the
car far enough for the wheel to turn freely.
4. Unscrew the wheel nuts completely and
lift off the wheel. Be careful when lifting
off the wheel that the threads of the studs
are not damaged.
Fitting
1. Clean the contact surfaces between the
wheel and hub and fit on the wheel.
Tighten the nuts until the wheel makes
good contact against the flange.
2. Lower the vehicle and tighten the nuts
alternately, re-fit the hub cap.
Do not rotate a raised wheel if the
car is fitted with a differential brake,
since turning the jacked-up rear
wheel will also move the other rear
wheel on the ground, and this may
cause the car to topple off the jack.
1
3
4
SERVICING
5 1