W Audio TP – 100 User Manual - page 4
OPERATING DETERMINATIONS
If this equipment is operated in any other way, than those described in
this manual, the product may suffer damage and the warranty
becomes void.
Incorrect operation may lead to danger e.g.: short-circuit,
burns, electric shocks, Lamp failure etc.
Do not endanger your own safety and the safety of others!
Incorrect installation or use can cause serious damage to people
and property!
Using the TP – 100/TP – 200 Receiver
1, Connect the output to your mixer/amplifier, using either a balanced
XLR cable or an unbalanced, 6.35mm jack plug cable.
2, Connect the AC adaptor to the receiver and plug into an appropriate
power outlet.
Using the TPT – 101/TPT – 201 Receiver
1, Connect outputs for channels A & B to your mixer/amplifier, using
either two balanced XLR cables for dual output or a single
unbalanced 6.35mm jack plug cable for mixed output of both channels.
2, Connect the AC adaptor to the receiver and plug into an appropriate
power outlet.
Using the wireless microphone transmitter/s
1, Slide the microphone ON/OFF/STANDBY switch to the on position.
2, Check the signal indicator is illuminated on your receiver to see if the
signal is being received.
3, If the signal indicator is illuminated, begin singing or speaking.
4, During the performance, slide the ON/OFF/STANDBY switch to
the STANDBY position when the microphone is not being used.
5, When the performance is over, slide the ON/OFF/STANDBY
switch to the OFF position to conserve the battery power.