W&D EPON ONU WD-5614 Quick Start Manual - 2 Hardware Connections
2 Hardware Connections
The rear panel of WD-5614 is described and depicted in the following picture.
Interface
Description
PON
SC/APC type connector for connecting to OLT
CATV
F-connector for connecting to TV
10/100/1000M (1~4)
Four Gigabit Ethernet Port for connecting to CPE devices
(eg. Home gateway, WiFi Router, PC, Set Top Box, etc.)
DC12V
DC Power Connector
PWR
Power turn on/off switch
Steps to connect the hardware:
(1) Put the AC-to-DC power adaptor onto the AC power electricity outlet and connect
the DC power output plug to the WD-5614 DC 12V socket.
(2) Connect the SC / APC type optical fiber from the optical Splitter to the SC / APC
type optical adapter on WD-5614.
(3) Connect an Un-shield Twisted Pair (UTP) CAT-5 cable from the RJ-45 connector of
WD-5614 to the device which is intended for link up.
(4) Connect a Coaxial Cable from the RF connector of WD-5614 to TV’s Video-In
connector. You can see the CATV service on the TV just as the same as before.
(5) Turn on Power Switch.