WAC Lighting H-LED160 Installation Instructions
WAC Lighting
www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. August, 2014
INSTALLATION INSTRUCTION
160 LED Track Luminaires
H-LED160, L-LED160, J-LED160
WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.
-
Read all instructions before installing.
-
System is intended for installation by a qualified electrician in accordance with the National Electrical Code and
local regulations.
-
Place the wall switch in the “OFF” position.
-
Go to the main fuse box, or circuit breaker. Switch “OFF” the circuit breaker switch(es) that control the power
to the fixture or room that you are working on.
AVERTISSEMENT
IMPORTANT : Coupez l’électricité avant TOUTE manipulation.
-
Lisez toutes les instructions avant d’installer.
-
Système est destiné à être installé par un électricien qualifié en conformité avec le code national de l’électricité et
les règlements locaux.
-
Placez l’interrupteur mural en position d’arrêt (« OFF »).
-
Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal en
position d’arrêt (« OFF »).
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are
worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.
OVERVIEW:
Fixtures are designed for use on WAC Lighting’s track systems.
LED TRACK FIXTURE
TRACK SYSTEMS
H-LED160 Series
H Track
L-LED160 Series
L Track
J-LED160 Series
J and J2 Track
INSTALLING ON TRACK:
1. Align the alignment tab on the adapter with the groove/slot
on the track (Figure 1).
2. Once aligned, insert adapter into track slot and rotate it 90°.
The arrow should point to the grooved side
of the track (Figure 2).
Groove
Alignment tab
1.
2.