1. DL manuals
  2. Wacker Neuson
  3. Portable Generator
  4. GH 3500
  5. Operator's Manual

Wacker Neuson GH 3500 Operator's Manual

Manual is about: Wacker Neuson GH 3500 High-frequency generator

Summary of GH 3500

  • Page 1

    Www.Wackergroup.Com high-frequency generator gh 3500 0207867en 001 2.2006 operator's manual.

  • Page 2

    Danger carbon monoxide using a generator indoors can kill you in minutes. Generator exhaust contains carbon monoxide (co). This is a poison you cannot see or smell. If you can smell the generator exhaust, you are breathing co. But even if you cannot smell the exhaust, you could be breathing co. • ne...

  • Page 3

    Contents operator’s manual 3 1 foreword . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2 symbols used . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 3 safety informat...

  • Page 4

    Contents 4.

  • Page 5

    Foreword operator's manual 5 1 foreword this operator's manual contains information and procedures for the safe opera- tion and maintenance of your wacker machine. In the interest of your own safety and to prevent accidents, you should carefully read through the safety informa- tion, familiarize you...

  • Page 6

    Symbols used 6 2 symbols used warning symbols this operator's manual contains safety regulations of the categories: danger, warning, caution. They should be followed to prevent danger to life and limb or damage to equip- ment or improper service. Instructions f this symbol indicates there is somethi...

  • Page 7

    Gh 3500 safety information operator's manual 7 3 safety information 3.1 general instructions state of the art this machine has been constructed with state-of-the-art technology according to the recognized rules of safety. Nevertheless, when used improperly, dangers to the life and limb of the operat...

  • Page 8

    Safety information gh 3500 8 maintenance regular maintenance is required in order for the machine to operate properly and reliably over time. Neglected maintenance work can make the machine danger- ous to use. Strictly observe the prescribed maintenance intervals. Do not use the machine if it requir...

  • Page 9

    Gh 3500 safety information operator's manual 9 operating controls always keep the operating controls of the machine dry, clean, and free of oil or grease. The function of operating levers or controls must not be manipulated or rendered ineffective. Cleaning always keep the machine clean and be sure ...

  • Page 10

    Safety information gh 3500 10 personal protective gear wear personal protective gear to avoid injuries or health hazards: non-skid, hard-toed shoes. Work gloves made of durable material. Overalls made of durable material. Hardhat. Ear protection. Ear protection this machine generates noise that exce...

  • Page 11

    Gh 3500 safety information operator's manual 11 loading loading ramps must be able to bear the load and be in a stable position. Make sure that no one can be endangered if the machine slips away or tips over or if parts suddenly move upward or downward. Put the operating controls and moving parts in...

  • Page 12

    Safety information gh 3500 12 3.5 operating combustion engines do not change the engine speed do not change the preset engine speed. This could cause engine damage. Dangers during operation combustion engines can be dangerous, particularly during operation and when refueling. Read and follow all war...

  • Page 13

    Gh 3500 safety information operator's manual 13 no operation in closed quarters do not operate the machine in closed quarters! In partially closed rooms such as tunnels, drifts or deep trenches, ensure suffi- cient ventilation by, for example, providing a powerful exhaust air fan. Danger of poisonin...

  • Page 14

    Safety information gh 3500 14 labels description warning hot surface. Guaranteed sound power level in db(a). Read the operator's manual carefully. Danger - carbon dioxide emission. - read the operator's manual! - unshielded flames are strictly prohib- ited. - switch off the engine before refueling. ...

  • Page 15

    Gh 3500 functional description operator's manual 15 4 functional description 4.1 components and control elements 4.2 functionality the generator generates 3-phase 42 v/200 hz protective voltage for driving vi- brators. Note: use either 32 a or 63 a plug receptacles. A sudden power drop can be the re...

  • Page 16

    Transport gh 3500 16 5 transport 5.1 lifting eyes and tie-down lugs warning read and follow all the safety instructions at the beginning of this operator's manual, see chapter safety information. Improper use can result in injury or serious material damage. Item description 1 lifting eyes 2 tie-down...

  • Page 17

    Gh 3500 transport operator's manual 17 5.2 transporting the machine f turn off the engine and allow it to cool down. F close the fuel tap. Note: we recommend that the fuel tank be emptied and the carburetor run dry prior to transporting it. Fuel could run out, e.G. If the machine is tilt- ed. F use ...

  • Page 18

    Operation gh 3500 18 6 operation 6.1 prior to starting the machine before you start the engine, check the following: f fuel level – the tank should be at least half full. F motor oil level –see 7.2 checking engine oil level (page 22). F air filter – see 7.5 cleaning the fuel dirt separator (page 25)...

  • Page 19

    Gh 3500 operation operator's manual 19 starting the engine f open the fuel tap (a1). F cold start: close the choke (d2). Warm start: open the choke (d1). Note: the engine is hand warm or hotter with warm start. F set the engine switch to "on" (b2). F push the throttle lever to the left (c2). F pull ...

  • Page 20

    Operation gh 3500 20 connecting machines note: do not use the main switch to switch on the machines. This could result in abrupt engine overload. F turn off all machine switches. F connect machines. F turn on the main switch. F turn on the machine switches separately. Never turn on more than one mac...

  • Page 21

    Gh 3500 maintenance operator's manual 21 7 maintenance 7.1 maintenance schedule have worn or damaged components replaced immediately! Warning danger of poisoning by exhaust fumes! Exhaust fumes contain toxic carbon monoxide that can lead to unconscious- ness or death. Always switch off the engine du...

  • Page 22

    Maintenance gh 3500 22 7.2 checking engine oil level f place the machine upright on a flat surface. F remove any dirt around the oil level dipstick. F remove the oil level dipstick (1) and wipe it with a clean, lint-free cloth. F screw the oil level dipstick all the way back in and pull it out again...

  • Page 23

    Gh 3500 maintenance operator's manual 23 7.3 changing the engine oil note: the work area should be covered with a waterproof sheet to protect the floor (protection of the environment). F place the machine upright on a flat surface. F bring the engine to a hand warm temperature, either by letting it ...

  • Page 24

    Maintenance gh 3500 24 7.4 cleaning the air filter / replacing the air filter inserts the air filter is equipped with two air filter inserts. Note: the air filter must be cleaned every day if conditions are adverse, dry, and dusty. Replace the air filter cartridges if it is no longer possible to rem...

  • Page 25

    Gh 3500 maintenance operator's manual 25 7.5 cleaning the fuel dirt separator f place the machine upright on a flat surface. F close the fuel tap (1). F remove any dirt around the fuel dirt separator (2). F place a container under the fuel dirt separator to catch the fuel. F use an open-end wrench t...

  • Page 26

    Maintenance gh 3500 26 7.6 checking / cleaning / replacing the spark plug f remove the spark plug connector. F remove the spark plug with a spark plug wrench. F clean the electrodes with a wire brush. F check the isolator (2) – if damaged, replace the spark plug. F check and adjust the electrode gap...

  • Page 27

    Gh 3500 troubleshooting operator's manual 27 8 troubleshooting generator engine malfunction cause remedy no voltage (or unstable) cable damage or contact prob- lem have it repaired short circuit in the stator coil have coil replaced abnormal noises (metallic noises or similar) shaft bearing defectiv...

  • Page 28

    Technical data gh 3500 28 9 technical data generator unit value item number 0610079 dimensions (l x w x h) mm 540 x 440 x 521 net weight kg 39 maximum output kva 4.2 continuous output kva 3.2 rated current a 41.2 rated voltage v 42 3~ frequency hz 200 output factor cos ϕ 0.8 plug receptacles 2 x 42 ...

  • Page 29

    Gh 3500 technical data operator's manual 29 engine unit value drive motor air-cooled, single-cylinder, four- stroke gasoline engine with auto- matic shutdown if there is insuffi- cient oil engine type wacker wm 210 rated output (*) * equivalent to the installed power output in accordance with the di...

  • Page 30

    Technical data gh 3500 30

  • Page 31: Ec Declaration of Conformity

    Ec declaration of conformity wacker construction equipment ag, preußenstraße 41, 80809 münchen certifies that the construction machine: type: high-frequency generator model: gh 3500 machine type number: 0610079 absolute installed power output: 3,2 kw was assessed in accordance with the directive 200...

  • Page 33

    Din en iso 9001 zertifikat.

  • Page 34

    Wacker construction equipment ag - preußenstraße 41 - 80809 münchen - tel.: +49-(0)89-3 54 02-0 - fax: +49-(0)89-3 54 02-390 wacker corporation - p.O. Box 9007 - menomonee falls, wi 53052-9007 - tel.: +1-(1)(262)-255-0500 - fax: +1-(1)(262)-255-0550 - tel.: (800)770-0957 wacker asia pacific operatio...