1. DL manuals
  2. Wacker Neuson
  3. Power Tool
  4. VP 1135R
  5. Operator's Manual

Wacker Neuson VP 1135R Operator's Manual

Manual is about: Vibroplate

Summary of VP 1135R

  • Page 1

    Www.Wackergroup.Com vibroplate vp 1135r vp 1135rw operator’s manual 0154567en 006 0306 0 1 5 4 5 6 7 e n.

  • Page 3: Vp 1135R/rw

    Vp 1135r/rw table of contents wc_bo0154567006entoc.Fm 1 1. Foreword 3 2. Safety information 4 2.1 laws pertaining to spark arresters ...................................................... 5 2.2 operating safety .................................................................................. 6 2.3 ...

  • Page 4: Table Of Contents

    Table of contents vp 1135r/rw wc_bo0154567006entoc.Fm 2 5. Maintenance 18 5.1 periodic maintenance schedule ..........................................................18 5.2 cleaning plate .....................................................................................18 5.3 drive belt ............

  • Page 5

    Wc_tx000001gb.Fm 3 california proposition 65 warning: engine exhaust, some of its constituents, and certain vehicle components, contain or emit chemicals known to the state of california to cause cancer and birth defects or other reproductive harm. 1. Foreword this manual provides information and pr...

  • Page 6: Safety Information

    Safety information vp 1135r/rw wc_si000018gb.Fm 4 2. Safety information this manual contains danger, warning, caution, notice and note callouts which must be followed to reduce the possibility of personal injury, damage to the equipment, or improper service. This is the safety alert symbol. It is us...

  • Page 7: Vp 1135R/rw

    Vp 1135r/rw safety information wc_si000018gb.Fm 5 2.1 laws pertaining to spark arresters notice: state health safety codes and public resources codes specify that in certain locations spark arresters be used on internal combustion engines that use hydrocarbon fuels. A spark arrester is a device desi...

  • Page 8: Safety Information

    Safety information vp 1135r/rw wc_si000018gb.Fm 6 2.2 operating safety familiarity and proper training are required for the safe operation of the machine. Machines operated improperly or by untrained personnel can be dangerous. Read the operating instructions contained in both this manual and the en...

  • Page 9: Vp 1135R/rw

    Vp 1135r/rw safety information wc_si000018gb.Fm 7 2.3 operator safety while using internal combustion engines internal combustion engines present special hazards during operation and fueling. Read and follow the warning instructions in the engine owner’s manual and the safety guidelines below. Failu...

  • Page 10: Safety Information

    Safety information vp 1135r/rw wc_si000018gb.Fm 8 2.4 service safety a poorly maintained machine can become a safety hazard! In order for the machine to operate safely and properly over a long period of time, periodic maintenance and occasional repairs are necessary. 2.4.1 do not attempt to clean or...

  • Page 11: Vp 1135R/rw

    Vp 1135r/rw safety information wc_si000018gb.Fm 9 2.5 label locations wpm_gr002141 vp 1135.

  • Page 12: Safety Information

    Safety information vp 1135r/rw wc_si000018gb.Fm 10 2.6 warning and informational labels wacker machines use international pictorial labels where needed. These labels are described below: label meaning warning! Always wear hearing and eye protection when operating this machine. Warning! Hot surface! ...

  • Page 13: Vp 1135R/rw

    Vp 1135r/rw safety information wc_si000018gb.Fm 11 danger! Engines emit carbon monoxide; operate only in well-ventilated area. Read the operator's manual for machine infor- mation. Danger! Before fueling, stop the engine. No sparks, flames, or burning objects near the machine. Use only fresh, clean ...

  • Page 14: Technical Data

    Technical data vp 1135r/rw wc_td000013gb.Fm 12 3. Technical data 3.1 engine data item number: vp 1135r 0009071 rev. 102 and lower vp 1135rw 0009251 rev. 101 and lower vp 1135r 0009071 rev. 103 and higher vp 1135rw 0009251 rev. 102 and higher engine engine make robin engine model ey150yd4520 ey153yd4...

  • Page 15: Vp 1135R/rw

    Vp 1135r/rw technical data wc_td000013gb.Fm 13 3.2 machine data 3.3 sound and vibration measurements the required sound specification, paragraph 1.7.4.F of 89/392/eec machinery directive, is: • the guaranteed sound power level (l wa ) = 105 db(a). • the sound pressure level at operator’s location (l...

  • Page 16: Technical Data

    Technical data vp 1135r/rw wc_td000013gb.Fm 14 3.4 dimensions mm (in.) wpm_gr002142 350 (14) 521 (21) 905 (36).

  • Page 17: Vp 1135R/rw

    Vp 1135r/rw operation wc_tx000063gb.Fm 15 4. Operation 4.1 recommended fuel the engine requires regular grade unleaded gasoline. Use only fresh, clean gasoline. Gasoline containing water or dirt will damage fuel system. Consult engine owner’s manual for complete fuel specifications. 4.2 application ...

  • Page 18: Operation

    Operation vp 1135r/rw wc_tx000063gb.Fm 16 4.4 to start see graphic: wc_gr000086 4.4.1 open fuel valve by moving lever down (a1). 4.4.2 if engine is cold, move choke lever to closed position (b1). If engine is hot, set choke to open position (b2). 4.4.3 open throttle by moving it to the right (c2). 4...

  • Page 19: Vp 1135R/rw

    Vp 1135r/rw operation wc_tx000063gb.Fm 17 4.6 operation run the engine at full throttle and allow the plate to pull itself along at its normal speed. When operating on an incline it may be necessary to assist the plate by pushing it forward slightly. When operating downhill hold the plate back sligh...

  • Page 20: Maintenance

    Maintenance vp 1135r/rw wc_tx000064gb.Fm 18 5. Maintenance 5.1 periodic maintenance schedule the chart below lists basic engine maintenance. Refer to the engine manufacturer’s operation manual for additional information on engine maintenance. 5.2 cleaning plate clean plate after use to remove dirt, ...

  • Page 21: Vp 1135R/rw

    Vp 1135r/rw maintenance wc_tx000064gb.Fm 19 5.3 drive belt see graphic: wpm_gr002143 on new machines or after installing a new belt, check the belt tension after first 20 hours of operation. Check and adjust the belt every 50 hours thereafter. To adjust the belt: 5.3.1 loosen the two screws (a) on t...

  • Page 22: Maintenance

    Maintenance vp 1135r/rw wc_tx000064gb.Fm 20 5.4 exciter lubrication see graphic: wc_gr000133 the bearings in the exciter assembly are splash lubricated and rotate at very high speed. It is important to maintain the exciter oil at the correct level and change it regularly. Check oil level in exciter ...

  • Page 23: Vp 1135R/rw

    Vp 1135r/rw maintenance wc_tx000064gb.Fm 21 5.5 spark plug see graphic: wc_gr000028 clean or replace the spark plug as needed to ensure proper operation. Refer to your engine operator’s manual. The muffler becomes very hot during operation and remains hot for a while after stopping the engine. Do no...

  • Page 24: Maintenance

    Maintenance vp 1135r/rw wc_tx000064gb.Fm 22 5.6 engine oil see graphic: wc_gr000087 5.6.1 drain oil while engine is still warm. Note: in the interests of environmental protection, place a plastic sheet and a container under the machine to collect any liquid which drains off. Dispose of this liquid i...

  • Page 25: Vp 1135R/rw

    Vp 1135r/rw maintenance wc_tx000064gb.Fm 23 5.7 air cleaner see graphic: wc_gr000161 the engine is equipped with a dual element air cleaner. Service the air cleaner frequently to prevent a carburetor malfunction. Notice: never run the engine without the air cleaner. Severe engine damage will occur. ...

  • Page 26: Maintenance

    Maintenance vp 1135r/rw wc_tx000064gb.Fm 24 5.8 cleaning fuel strainer see graphic: wc_gr000131 5.8.1 to remove water and dirt, close the fuel lever and remove the fuel strainer. 5.8.2 inspect the fuel strainer (a) for water and dirt. 5.8.3 after removing any dirt and water, wash the fuel cup with a...

  • Page 27: Vp 1135R/rw

    Vp 1135r/rw maintenance wc_tx000064gb.Fm 25 5.10 adjusting the engine speed see graphic: wc_gr000130 adjust the engine to a full load speed. See technical data. To adjust the engine speed: 5.10.1 set the coarse adjustment by attaching the governor spring (a) to the center hole of the throttle arm. 5...

  • Page 28: Maintenance

    Maintenance vp 1135r/rw wc_tx000064gb.Fm 26 5.11 troubleshooting 5.12 storage if plate is being stored for more than 30 days: 5.12.1 remove loose stones and dirt from plate. 5.12.2 clean engine cylinder cooling fins. 5.12.3 clean or replace air filter. 5.12.4 change exciter oil. 5.12.5 change engine...

  • Page 29: Vp 1135R/rw

    Vp 1135r/rw maintenance wc_tx000064gb.Fm 27 5.13 lifting machine see graphic: wpm_gr002144 see technical data for weight of machine. To lift machine manually: 5.13.1 stop the engine. 5.13.2 obtain help from a partner and plan the lift. To avoid burns or fire hazards, let the engine cool before trans...

  • Page 30: Maintenance

    Maintenance vp 1135r/rw wc_tx000064gb.Fm 28 5.14 transporting machine see graphic: wpm_gr002145 to avoid burns or fire hazards, let engine cool before transporting machine or storing indoors. 5.14.1 turn fuel valve to the off position and keep the engine level to prevent fuel from spilling. 5.14.2 t...

  • Page 31

    Vp 1135r_q_2003.Fm heinz gengnagel president & ceo wacker machinery philippines wacker machinery philippines, inc. 4126 first cavite, industrial estate (fcie) governor’s drive, brgy. Langkaan dasmariñas, cavite, philippines (tel) +63 2 580 7110 (fax) +63 2 580 7122 date / datum / fecha / date ec dec...

  • Page 32

    Wacker construction equipment ag · preußenstraße 41 · d-80809 münchen · tel.: +49-(0)89-354 02 - 0 · fax: +49 - (0)89-354 02-390 wacker corporation · p.O. Box 9007 · menomonee falls, wi 53052-9007 · tel. : +1-(1)(262) 255-0500 · fax: +1-(1)(262) 255-0550 · tel. : (800) 770-0957 wacker asia pacific o...