1. DL manuals
  2. Wacker Neuson
  3. Tools
  4. VPR 1330
  5. Operator's Manual

Wacker Neuson VPR 1330 Operator's Manual

Manual is about: Vibroplate

Summary of VPR 1330

  • Page 1

    Www.Wackergroup.Com vibroplate vpr 1330 operator’s manual 0154577en 001 1102 0 1 5 4 5 7 7 e n.

  • Page 2

    Belgie 1730 asse-mollem assesteenweg 17 tel. (32) 02-4528509+07 4040 herstal 4 avenue 9800 deinze kortrijkse steenweg 400 tel. (09)-386 8529 b - 6041 gosselies rue adrienne bolland s/n tel. 071-372450 ÇeskÁ republika 19402 praha 9-hloubetin kolbenova 259 tel. (0042) 2 862165 danmark 2690 karlslunde ...

  • Page 3: Vpr1330

    Vpr1330 table of contents wc_bo0154577001entoc.Fm 1 1. Foreword 3 2. Safety information 4 2.1 laws pertaining to spark arresters ...................................................... 4 2.2 operating safety .................................................................................. 5 2.3 oper...

  • Page 4: Table Of Contents

    Table of contents vpr1330 wc_bo0154577001entoc.Fm 2 5. Maintenance 20 5.1 periodic maintenance schedule ..........................................................20 5.2 cleaning plate .....................................................................................20 5.3 drive belt ................

  • Page 5: Foreword

    Foreword wc_tx000001gb.Fm 3 california proposition 65 warning: engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the state of california to cause cancer and birth defects or other reproductive harm. 1. Foreword this manual provides informatio...

  • Page 6: Safety Information

    Safety information vpr 1330 wc_si000031gb.Fm 4 2. Safety information this manual contains danger, warning, caution, and note callouts which must be followed to reduce the possibility of personal injury, damage to the equipment, or improper service. This is the safety alert symbol. It is used to aler...

  • Page 7: Vpr 1330

    Vpr 1330 safety information wc_si000031gb.Fm 5 2.2 operating safety familiarity and proper training are required for the safe operation of equipment! Equipment operated improperly or by untrained personnel can be dangerous! Read the operating instructions contained in both this manual and the engine...

  • Page 8: Safety Information

    Safety information vpr 1330 wc_si000031gb.Fm 6 2.3 operator safety while using internal combustion engines internal combustion engines present special hazards during operation and fueling! Read and follow warning instructions in engine owner's manual and safety guidelines below. Failure to follow wa...

  • Page 9: Vpr 1330

    Vpr 1330 safety information wc_si000031gb.Fm 7 2.4 service safety poorly maintained equipment can become a safety hazard! In order for the equipment to operate safely and properly over a long period of time, periodic maintenance and occasional repairs are necessary. 2.4.1 do not attempt to clean or ...

  • Page 10: Safety Information

    Safety information vpr 1330 wc_si000031gb.Fm 8 2.5 label locations wc_gr000182 1 2 3 4 5 6 7 1 2 warning warnung advertencia avertissement 10w30

  • Page 11: Vpr 1330

    Vpr 1330 safety information wc_si000031gb.Fm 9 2.6 warning and informational labels wacker machines use international pictorial labels where needed. These labels are described below: label meaning to prevent hearing loss, wear hearing protec- tion when operating this machine. Read the operator's man...

  • Page 12: Safety Information

    Safety information vpr 1330 wc_si000031gb.Fm 10 warning! Hand injury if caught in moving belt. Always replace belt guard. Caution! Read and understand the supplied operator's manual before operating this machine. Failure to do so increases the risk of injury to yourself or others. Caution! Lifting p...

  • Page 13: Vpr 1330

    Vpr 1330 safety information wc_si000031gb.Fm 11 this machine may be covered by one or more patents. Label meaning.

  • Page 14: Safety Information

    Safety information vpr 1330 wc_si000031gb.Fm 12 2.7 operating labels wacker machines use international pictorial labels where needed. These labels are described below: label meaning open fuel flow valve. Push or turn engine switch to on position. Close choke. Place throttle in the idle position. Pul...

  • Page 15: Vpr 1330

    Vpr 1330 safety information wc_si000031gb.Fm 13 push or turn engine switch to off position. Open choke. Place throttle in the fast position. Throttle control lever: turtle = idle or slow rabbit = full or fast label meaning 1.

  • Page 16: Technical Data

    Technical data vpr 1330 wc_td000014gb.Fm 14 3. Technical data 3.1 engine data vpr 1330 0006512 rev. 102 and lower vpr 1330 0006512 rev. 103 and higher engine engine make robin engine model ey15 (w1-145) eh122 (yd 4020) rated power kw (hp) 2.6 (3.5) 2.9 (4.0) engine speed - full load rpm 3500 ± 100 e...

  • Page 17: Vpr 1330

    Vpr 1330 technical data wc_td000014gb.Fm 15 3.2 machine data 3.3 sound and vibration specifications the required sound specification, paragraph 1.7.4.F of 89/392/eec machinery directive, is: • the sound pressure level at operator’s location (l pa ) = 94 db(a) • the sound power level (l wa ) = 103 db...

  • Page 18: Technical Data

    Technical data vpr 1330 wc_td000014gb.Fm 16 3.4 dimensions mm (in.) w c _ g r 0 0 0 1 8 1 6 0 1 ( 2 3 . 5 ) 6 5 9 ( 2 6 ) 1 0 7 8 ( 4 2 . 5 ) 3 0 0 ( 1 3 . 2 5 ) 8 8 4 ( 3 5 ).

  • Page 19: Vpr 1330

    Vpr 1330 operation wc_tx000106gb.Fm 17 4. Operation 4.1 recommended fuel the engine requires regular grade unleaded gasoline. Use only fresh, clean gasoline. Gasoline containing water or dirt will damage fuel system. Consult engine owner’s manual for complete fuel specifications. 4.2 before starting...

  • Page 20: Operation

    Operation vpr 1330 wc_tx000106gb.Fm 18 4.4 to stop see graphic: wc_gr000183 4.4.1 reduce engine rpm to idle by moving throttle completely to the left (d1). 4.4.2 turn engine switch to "off" (b2). 4.4.3 close fuel valve (a2). 4.5 application this plate is designed for compacting loose, granular soils...

  • Page 21: Vpr 1330

    Vpr 1330 operation wc_tx000106gb.Fm 19 4.6 operation run the engine at full throttle and allow the plate to pull itself along at its normal speed. When operating on an incline it may be necessary to assist the plate by pushing it forward slightly. When operating downhill hold the plate back slightly...

  • Page 22: Maintenance

    Maintenance vpr 1330 wc_tx000107gb.Fm 20 5. Maintenance 5.1 periodic maintenance schedule the chart below lists basic engine maintenance. Refer to engine manufacturer’s operation manual for additional information on engine maintenance. 5.2 cleaning plate clean plate after use to remove dirt, stones,...

  • Page 23: Vpr 1330

    Vpr 1330 maintenance wc_tx000107gb.Fm 21 5.3 drive belt see graphic: wc_gr000185 on new machines or after installing a new belt, check belt tension after first 20 hours of operation. Check and adjust belt every 50 hours thereafter. To adjust belt: 5.3.1 remove the two screws (b) at the bottom of the...

  • Page 24: Maintenance

    Maintenance vpr 1330 wc_tx000107gb.Fm 22 5.4 exciter lubrication see graphic: wc_gr000184 the bearings in the exciter assembly are splash lubricated and rotate at very high speed. It is important to maintain the exciter oil at the correct level and change it regularly. Check oil level in exciter eac...

  • Page 25: Vpr 1330

    Vpr 1330 maintenance wc_tx000107gb.Fm 23 5.5 spark plug see graphic: wc_gr000028 clean or replace spark plug as needed to ensure proper operation. Refer to the engine owner’s manual. The muffler becomes very hot during operation and remains hot for a while after stopping the engine. Do not touch the...

  • Page 26: Maintenance

    Maintenance vpr 1330 wc_tx000107gb.Fm 24 5.6 engine oil see graphic: wc_gr000087 5.6.1 drain oil while engine is still warm. Note: in the interests of environmental protection, place a plastic sheet and a container under the machine to collect any liquid which drains off. Dispose of this liquid in a...

  • Page 27: Vpr 1330

    Vpr 1330 maintenance wc_tx000107gb.Fm 25 5.7 air cleaner see graphic: wc_gr000088 the engine is equipped with a dual element air cleaner. Service the air cleaner frequently to prevent a carburetor malfunction. Caution: never run the engine without the air cleaner. Severe engine damage will occur. Ne...

  • Page 28: Maintenance

    Maintenance vpr 1330 wc_tx000107gb.Fm 26 5.8 cleaning fuel strainer see graphic: wc_gr000089 5.8.1 turn fuel valve off. 5.8.2 remove bowl (a) gasket (b) and screen (c). 5.8.3 wash them thoroughly in a nonflammable solvent. Dry them and reinstall. 5.8.4 turn fuel valve on and check for leaks. 5.9 thr...

  • Page 29: Vpr 1330

    Vpr 1330 maintenance wc_tx000107gb.Fm 27 5.10 adjusting idle speed see graphic: wc_gr000186 adjust the idle when the engine is warm. 5.10.1 start the engine and allow it to warm up for a minute. 5.10.2 with the throttle in lowest (slowest) position, adjust the idle speed screw (a) to obtain the corr...

  • Page 30: Maintenance

    Maintenance vpr 1330 wc_tx000107gb.Fm 28 5.11 troubleshooting 5.12 storage if plate is being stored for more than 30 days: 5.12.1 remove loose stones and dirt from plate. 5.12.2 clean engine cylinder cooling fins. 5.12.3 clean or replace air filter. 5.12.4 change exciter oil. 5.12.5 change engine oi...

  • Page 31: Vpr 1330

    Vpr 1330 maintenance wc_tx000107gb.Fm 29 5.13 lifting machine see graphic: wc_gr000359 see technical data for the weight of the machine. To lift machine manually: 5.13.1 stop the engine. 5.13.2 obtain help from a partner and plan the lift. 5.13.3 grasp the machine by its cage (a) and lifting handle ...

  • Page 32: Maintenance

    Maintenance vpr 1330 wc_tx000107gb.Fm 30 5.14 transporting machine see graphic: wc_gr000356 to avoid burns or fire hazards, let engine cool before transporting machine or storing indoors. 5.14.1 turn fuel valve to the off position and keep the engine level to prevent fuel from spilling. 5.14.2 tie d...

  • Page 33

    Ec - conformity certificate eg-konformitÄtserklÄrung ce-certificado de conformidad certificat de conformitÉ de la cee wacker corporation, n92 w15000 anthony avenue, menomonee falls, wisconsin usa hereby certifies that the construction equipment specified hereunder: bescheinigt, daß das baugerät: cer...

  • Page 35

    Deutschland 80809 mÜnchen preussenstr. 41 tel. 089/35 40 21 fax 089/35 40 23 90 85757 karlsfeld (wlz) tel. 018131-59780 21109 hamburg fax 040/75 73 90 tel. 040/75 15 66 24145 kiel fax 0431/71 46 25 tel. 0431/71 15 25 23566 lübeck fax 0451/62 56 15 tel. 0451/62 56 19 28307 bremen-mahndorf fax 0421/48...

  • Page 36

    Wacker corporation - p. O. Box 9007 - menomonee falls, wi 53052-9007 - tel.: (262)-255-0500 - fax: (262)-255-0550 wacker-werke gmbh & co. Kg - preußenstraße 41 - 80809 münchen - tel.: +49-(0)89-354 02-0 - fax: +49-(0)89-35 402-390 united states corporate office menomonee falls, wi 53052 n92 w15000 a...