Waeco CA-35 Instruction Manual - page 9
10
CoolFun CA-35
10
➤
Ensure that
– The thermostat control for 220 V – 240 V operation (
2
2, page 4) is in
the “0” position
– The battery plug is not connected.
➤
Press in the rotary switch (
2
3, page 4) and hold it in for approx. 10 s to
force out any air in the hose connection.
➤
Turn the rotary switch (
2
3, page 4) towards “ ”.
✔
You will hear a clicking noise: the Piezo ignition is trying to light
the flame. When the flame is burning, the cooler is ready for use.
➤
If the flame does not ignite, repeat the procedure.
Tip!
If it is not possible to light the gas with the Piezo lighter due to high air
humidity, you can light the gas burner with a match at the opening in the back
panel of the device when the rotary switch is pressed in.
➤
Check that all hose lines and all connections are in a technically perfect
condition at regular intervals.
➤
To switch off the cooler, first close the valve on the bottle and then
turn the rotary switch (
2
3, page 4) completely shut in a clockwise direction.
CA-35_M-51201 2/3/06 8:29 AM Page 10