Waeco CoolMatic HDC-161 Instruction Manual - Safety Instructions
HDC-161, HDC-221
Safety instructions
7
6
1, page 5: this refers to an element in an illustration. In this case, item 1
in figure 6 1 on page 5.
Please observe the following safety instructions.
2
Safety instructions
Caution!
Dometic WAECO International will not be held liable for claims for
damage resulting from the following:
– Damage to the device resulting from mechanical influences and
overvoltage
– Alterations to the device made without the explicit permission of
Dometic WAECO International
– Usage for purposes other than those described in the
installation manual
2.1
General safety
z
Have a trained technician make installations in wet rooms.
z
Do not operate the device if it is visibly damaged.
z
This device may only be repaired by qualified personnel.
Inadequate repairs can lead to considerable hazards.
Should your device need to be repaired, please contact
WAECO customer services.
z
Do not open the refrigerant circuit under any circumstances.
z
Place the device in a dry location where it is protected against
splashing water.
z
Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
z
Ensure that the ventilation slots are not covered.
z
The device is not suitable for storing caustic materials or
materials containing solvents.
z
Before starting up the device for the first time, check whether
the operating voltage and the battery voltage correspond
(see type plate).
z
Danger of fatal injuries!
When using the device on boats: if the device is powered
by the mains, ensure that the power supply has a ground fault
interrupter circuit.
hdc161-221.book Seite 7 Donnerstag, 2. September 2010 9:44 09