WAFER DC200 Manual - page 4
WAFER GSM-KEY-DC REMOTE CONTROL UNIT
http://www.waferstar.com
GSM-KEY PC Program Software interface
1. Setting and Log page switch
2. Open saved file
3. Save units phone numbers in your computer for future changes
4. Save in a new file name
5. Communitcaton selection ,Com port configuration
6. Connect to the unit
7. Select Language
8. Setting Tab – Insert regular/Special phone numbers,miscellaneous
9. Log Tab
10. Phone numbers Tab – Add regular phone numbers 200
11. Special phone numbers Tab – Add special phone numbers 750
12. Alarm Phone numbers Tab – Add alarm phone numbers 5
13. Miscellaneous Tab
The following compand is used in the GSM-KEY :
#PWD:
Password
#CAP:
Change
password
#WHL:
White List (add or remove numbers)
#GOT:
Gate
pulse
time
#ALARM:
Alarm information setting
#MODE:
Relay mode
#CSQ:
Check
Signal
Quality
#SCA:
Set service center address
#STATUS:
Check status
#OUT:
Use the SMS to control the switch to ON or OFF
Once you issue a command with an SMS, you will receive a confirmation SMS with OK
if everything is correct or Err if there is an Error.