Wafer gsm-relay remote control unit http://www.Waferstar.Com gsm-relay manual shanghai wafer microelectronics co.,ltd.
Wafer gsm-relay remote control unit http://www.Waferstar.Com gsm-relay operating instructions product description wafer gsm-relay is an electronic board with an on-board gsm modem.The purpose of this device is to do the real time and interactive gsm remote control by means of a gsm phone. Connector ...
Wafer gsm-relay remote control unit http://www.Waferstar.Com gsm-relay in a place where there is gsm signal coming from the operator you want to use. Check it with a phone before proceeding with the installation. If you need to install the device in a place with little signal, you may consider using...
Wafer gsm-relay remote control unit http://www.Waferstar.Com the following compand is used in the gsm-relay : #pwd: password #cap: change password #whl: white list (add or remove numbers) #got: relay working output delay time #mode: relay mode #csq: check signal quality #sca: set service center addr...
Wafer gsm-relay remote control unit http://www.Waferstar.Com acknowledge would be : whl01 set to 61143815 ok where 01 is the position in the list and 61143815 is the number enabled. Please note that it is possible to program up to a maximum of 18 digits for a number. If it has more digits you should...
Wafer gsm-relay remote control unit http://www.Waferstar.Com if setup to mode0,that is momentary pulse mode, when you call the sim card number , device will toggle the relay and delay a got timer ,then the relay will back the previous status. If setup to mode1,that is ratchet relay mode,when you cal...
Wafer gsm-relay remote control unit http://www.Waferstar.Com your phone in the sms settings (if you use th esame operator). • to program the service center number for gsm-relay we use the following command: #pwd123456#sca+85290100000 if use this command not properly, that sim card will not send the ...
Wafer gsm-relay remote control unit http://www.Waferstar.Com troubleshooting no led is on after power up · check the power supply. · check the wires is connected well. Gsm led d6 is not flash slowly (gsm led normally flash quickly when power off and when it connected to gsm net ,then would flash aro...
Wafer gsm-relay remote control unit http://www.Waferstar.Com relay connection example to output driver the relay control outputs are suitable to control seven different household and other devices as are air-conditioning and heating,connected directly or through external relay modules. Each relay ou...
Wafer gsm-relay remote control unit http://www.Waferstar.Com this brochure provides an overview of the products and services of weifu gsm modules, for further information and queries kindly contact: email: coinco_cn@yahoo.Com.Cn web: www.Waferstar.Com tel: 0086-21-51870528 also accessible via our on...
