Wagan Power Dome LT 2464 User Manual - page 11
©2015 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
www.wagan.com
11
TROUBLESHOOTING
Problem
Cause
Solution
Air compressor shut-off.
High temperature
protection.
Allow the Power Dome cool for about 10 minutes.
Lack of power output.
Power Dome battery
voltage is below 10 volts.
Recharge the Power Dome immediately.
Excessive current drawn
by appliance being
operated.
Reduce load to maximum wattage.
1. Turn off the device and inverter.
2. Disconnect device.
3. Turn the inverter on and let it run for a
minimum of 2 minutes.
4. Turn inverter off.
5. Quickly plug device into inverter.
6. Turn on both the inverter and the device.
Inverter fuse blown.
Check and replace if necessary. Be sure
replacement fuse is the same type and rating.
Television/power
tool will not start.
Required wattage
exceeds Power Dome
peak surge for start-up.
Toggle the Inverter/USB Switch on and off in
quick succession for 5 times. If the device does
not start, the device is not compatible with this
type of inverter.
Television Interference.
Picture breaking up
(static)
Place the Power Dome as far as possible from
the TV, antenna, and coaxial cable.
TV station may be out of range.
Static/noise interference
in audio system.
Sound system has weak
alternating current
shielding.
Do not use the Power Dome’s inverter with low-
quality audio AC filtering system.
Replace audio system with high quality noise
filtering.