WAGNER HC 920 Operating Manual - page 42

40

HC920•HC940•HC960

GB

Starting operation 

4. 

Starting operation

4.1 

Swivel mechanism of the material feed 

pump

Danger

Be careful, as the moving parts of the swivel 

mechanism can crush fingers and feet.

1. Transport position (fig. 8)

Transport unit only when the material feed pump is in the 

horizontal position.

Swiveling the material feed pump to a horizontal position also 

allows removal of the pump from the coating material container.

Ensure that the locking pin locks.

2.0 Operating position I (fig. 9)

Swiveling the material feed pump to a vertical position allows 

the material feed pump to be immersed in the coating material 

container.

2.1 Operating position II (fig. 10)

Swivel material feed pump to a slanted (45°) postion if using the 

container suction system (accessory). In this position, there is 

open space under the material feed pump.

4.2 

Changing the material feed pump position

Danger

Be careful, as the moving parts of the swivel 

mechanism can crush fingers and feet.

 1. Griphandle(fig.11,item1)withonehand.

  2.   Push locking pin (2) with the other hand.

  3.  Swivel material feed pump up or down to the desired 

position, until the locking pin (2) locks into the new 

position.