WAGNER WideShot Owner's Manual - Title

16

English

Title

1. Remove all parts from the pump housing assembly.

3. Clean all parts thoroughly with the brush provided using a

solution appropriate to the type of material you sprayed.

Reassembly (all materials)

1. Place the pump housing ring over the piston chamber.

Slide the spring onto the front end of the piston.  Insert

the piston into the rear of the piston chamber.

2. Insert swirl valve into front of the piston chamber.  Thread

the spray tip onto the pump housing.  

3. Line up the tab on the pump housing with the notch in the

material container.  Twist the ring to thread the cup onto

the pump.

4. Take spray cartridge and slide the rear of the piston into the spray gun.  Make sure the pegs 

(a) on the cartridge line up with

the guides 

(b) at the bottom of the sprayer. Press cartridge up until it locks into place.  Pull on the container to make sure

assembly is locked into place.

3. NOTE - Make sure to completely remove all material

from the inside of the piston chamber by scrubbing

with the brush.  Even a small amount of material can

dry like glue and keep the piston from moving,

causing damage to the sprayer.

4. NOTE - Make sure to keep the vent hole (a) on the

pump housing clean and unblocked or a vacuum can

build up in the container and cause damage to the

sprayer.  A toothpick or straightened paper clip can

be used to clean it.

(a)

(a)

(b)

Cleaning the components (oil-based materials)