Summary of Z100
Page 1
1 mains clipper consumer mains clipper instructions.
Page 2: Contents
2 mains clipper contents general user information page 3 important safeguards page 6 product description page 9 operating instructions page 9 care and cleaning page 11 cutting your hair page 13 disposal page 17 wiring page 17 product registration page 18 guarantee page 19 please read all instruction...
Page 3: General User Information
3 mains clipper general user information information about using the operation manual ► before using the appliance for the first time, you must read and understand the operation manual completely. ► consider the operation manual as part of the product and store it in a safe and accessible place. ► i...
Page 4
4 mains clipper 1 a b d f g e h c.
Page 5
5 mains clipper 4 3 2 6 5 7 8 9 0,5 – 1,0 mm a b b a b a b a.
Page 6: Important Safeguards
6 mains clipper please retain this leaflet for future reference. Important safeguards when using your electrical appliance, basic safety precautions should always be followed, including the following: intended use • only use hair clippers to cut human head hair. • only use animal clippers to cut ani...
Page 7: Hazards
7 mains clipper ► use this appliance only for its intended purpose. ► repairs to the appliance must only be carried out by a trained electrician in accordance with the electrical engineering regulations! Hazards please adhere to the following safety instructions! Danger! Electric shock due to damage...
Page 8: Handling
8 mains clipper warning! Injuries due to incorrect handling ► switch off the appliance and unplug from outlet when not in use, before putting on or taking off attachments and also before cleaning the appliance. Caution! Danger of product damage. ► never use your appliance without paying attention! A...
Page 9: Product Description
9 mains clipper product description description of parts (fig. 1) a blade set b cutting length adjustment lever c on/off switch d mains cable e adjusting screw f blade guard g oil for blade set h cleaning brush not pictured attachment combs and various accessories (depending on model) operating inst...
Page 10
10 mains clipper if your clipper has a power screw, it has been adjusted for peak efficiency before leaving the factory. However, if the voltage in your home is low, you may need to readjust it. To adjust power, first use the on/off switch to turn appliance on, then use the plastic brush, a screwdri...
Page 11: Care And Cleaning
11 mains clipper 1. Switch the appliance off using the on/off switch (fig. 2b) and disconnect from the power supply. 2. Undo the screws on the blade set; remove the bottom blade and the top blade (fig. 7). When assembling, the bottom blade and the top blade should be aligned as follows: f set the ad...
Page 12
12 mains clipper f remove the attachment comb (fig. 5b) after every use. Remove the hair clippings from the blade set with the cleaning brush. F if a thorough cleaning is required, the blade set can be removed. See chapter changing the blade set. F after cleaning the blade set, we recommend using hy...
Page 13: Cutting Your Hair
13 mains clipper f hold appliance more flatly to the skin. Cause: gap between the front edge of the bottom blade and the front edge of the top blade is not correctly aligned. F align the bottom blade (fig. 7). Appliance is not working. Cause: defective power supply. F make sure that contact between ...
Page 14
14 mains clipper the hair, cutting only a small amount at a time. 3.Repeat around sides and back of head. If you desire shorter hair, either change to a lower number attachment comb, or apply more pressure and less lift away from head with the present attachment comb. This entire procedure requires ...
Page 15
15 mains clipper short tapered styles if a short tapered cut on the sides and back is desired, please follow the following diagram: starting with the desired attachment comb, cut from the back of the neck to the crown. Hold the attachment comb flat against the head and slowly move the clipper throug...
Page 16
16 mains clipper bald fade (only applies to baldfader clipper) your wahl baldfader clipper is designed to allow you to create and maintain extremely close hair styles, such as the ‘bald fade’. Its fine-tooth, steel blades and powerful cool running motor give a close, smooth cut every time. 1.This st...
Page 17: Disposal
17 mains clipper 6.To create a part, pick a spot off centre. Pull the scalp tight and with the end of the blade perpendicular to the head, move the clipper back and forth to cut a line. Comb through it and cut again to make sure the cut is precise. Bald cut for a totally bald look, follow the direct...
Page 18: Product Registration
18 mains clipper the wires in the mains lead are coloured in accordance to the following code: blue neutral (n) brown live (l) this lead is fitted with a 3 pin plug which has a 3 amp fuse fitted. If the plug supplied is not suitable for your socket or becomes damaged, it should be cut off and dispos...
Page 19: Guarantee
19 mains clipper guarantee this product is guaranteed against defects in material and workmanship for a period of three years from the date of original purchase or receipt as a gift. Should this product become defective during the guarantee period, return it to the store of purchase together with yo...
Page 20
20 mains clipper wahl (uk) limited herne bay trade park sea street herne bay kent ct6 8jz. Customer services t : 01227 740066 www.Wahl.Co.Uk form no. Z100 rev7 01-14.