Wahlberg Projector Shutter User Manual - page 2
Jægergårdsgade 152/05A
DK-8000 Aarhus C
DENMARK
WWW.WAHLBERG.DK
WWW.WAHLBERG.DK · TELEPHONE +45 86 18 14 20 · CELL PHONE +45 40 52 20 88 · EMAIL: mads@wahlberg.dk
Optional -- ON/OFF function.
The shutter with DMX interface has an optional ON/OFF function.
This option makes it possible to use the shutter without DMX – signal.
To do this you need to make a special cable, with the required connections to a button ore a relay.
You can also buy a separate ON/OFF switchbox at the web shop.
1 Setting of ON/OFF address. When the address is set to 700 you can use the ON/OFF function.
Note – the 10’ digit should bee set to 0, if set to1, you can test the ON/OFF function.
2 Setting the operation angle.
The operation angle is set on the 1’ digits on the address.
When set to 700 you have a small operation angle, when set to 709 you have the maximum
operation angle.
3 Pin Connection on the 5 pole XLR plug.
Pin 1 - GND
Pin 2 - DMX +
Pin 3 - DMX -
Pin 4 - + 5 volt for the switch light, sources only 0,05 amp.
Pin 5 - Sense signal for the switch , shutter is active when connected to GND