Waldorf BP8080E Installation And Operation Manual - page 16
14
Operation
Turning on the Main Element and Setting the Desired Temperature
1.
Rotate the thermostat control knob anti-clockwise to the desired heat setting.
2.
The main element will only operate when the pan is in the flat cooking position. Tilting the pan will
automatically cut power to the main element.
3.
Turn the thermostat control knob to the desired heat setting. The temperature will be
thermostatically controlled at this selected heat setting.
Operating the Water Supply Valve
1.
The temperature control thermostat should be turned ON to hold solenoid water supply valve open
and allow water supply to the appliance.
2.
To add water to the cooking product or for cleaning, turn the water tap anti-clockwise with the pan
in the down position and the pan lid up.
3.
The water flow can be controlled by adjusting the water tap position.
NOTE: A ¼ turn anti-clockwise is FULLY open.
Tilting the Pan
BP8080E and BP8120E Models
a. To tilt the pan, turn the pan tilt handle clockwise. The heating element will automatically switch
‘Off’ when the pan is raised.
b. With the pan returned to its down lowered, the heating element will turn back ‘On’.
BP8080EE and BP8120EE Models
a. To tilt the pan up or down, depress the pan tilt control switches on the front panel, with the
corresponding direction arrow marking and hold the pan tilt control switch depressed as long as
required.
b. Releasing the switch will stop the tilt operation and the pan will rest in the chosen position.
NOTE: The electric lift mechanism will only operate if the pan lid is in the raised position.
Turning ‘Off’ the Main Element
1.
To turn ‘Off’ the main element, set the thermostat control knob to the ‘OFF’ position. The main
element will now switch ‘Off’.
WARNING:
CHECK
THAT
THE
PAN
LID
IS
IN
THE
FULLY
RAISED
POSITION
BEFORE
TILTING
THE
PAN
UP
.
CHECK
THAT
THE
SPACE
BEHIND
AND
ON
BOTH
SIDES
OF
THE
PAN
IS
CLEAR
OF
ANY
OBSTRUCTIONS
BEFORE
TILTING
THE
PAN
DOWN
.