Waldorf FN8120GE Installation And Operation Manual - page 18
16
Operation
TURN ON FRYER
Press ON / OFF key to turn ‘ON’ Control Panel.
droP
H.EAt
When oil is Up To Temperature, display will show the following.
If ‘t - 1’ selected in Advanced
Program Settings, display will show
Actual Temperature of oil.
Neon Dot Indicates Heating is‘ON’
If Melt cycle is active, display will show the
following. Refer to Controller Advanced
Programming Mode for available settings.
Fryer Operation (Flow Chart)
Refer to ‘Controller Basic Programming Mode’ at the start of this section for basic programmable settings
for the controller.
Refer to ‘Controller Advanced Programming Mode’ section for controller advanced programming.
If Melt Cycle is turned ON.
If Melt Cycle is turned OFF.
If ‘t - 0’ selected in Advanced
Program Settings, display will show
the following.
TURN ON FRYER
Press ON / OFF key to turn ‘ON’ Control Panel.
droP
H.EAt
When oil is up to temperature, display will show the following.
If
‘t - 1’
selected in Advanced
Program Settings,
Actual Temperature of oil is displayed.
If
‘t - 0’
selected in Advanced
Program Settings, display will show
the following.
Display will show the following. Refer to Controller
Advanced Programming Mode for settings.
Fryer can now be used without using the Timers, if required.
Fryer can now be used without using the Timers, if required.