- DL manuals
- Waldorf
- Oven
- GP8121GE
- Installation And Operation Manual
Waldorf GP8121GE Installation And Operation Manual
Summary of GP8121GE
Page 1
I n s t a l l a t i o n a n d o p e r a t i o n m a n u a l gp8910ge gp8910gec gp8121ge gp8121gec gas griddle range electric oven date purchased serial number dealer service provider 230560-12 for use in gb & ie gpl8910ge gpl8910gec gpl8121ge gpl8121gec.
Page 2
The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in writing by the manufacturer. In line with policy to continually develop and improve its products, moffat ltd. Reserves the right to change the specifications and desig...
Page 3
Contents waldorf gas griddle electric oven ranges gp [l] 8910ge gas griddle range electric static oven - 900 mm. Gp [l] 8910gec gas griddle range electric convection oven - 900 mm. Gp [l] 8121ge gas griddle range electric static oven - 1200 mm. Gp [l] 8121gec gas griddle range electric convection ov...
Page 4
2 introduction we are confident that you will be delighted with your waldorf gas griddle range electric oven , and it will become a most valued appliance in your commercial kitchen. To ensure you receive the utmost benefit from your new waldorf appliance, there are two important things you can do. F...
Page 5
3 specifications model numbers covered in this specification gp [1] 8910ge gas griddle range static electric oven - 900mm. Gp [1] 8910gec gas griddle range convection electric oven - 900mm. Gp [1] 8121ge gas griddle range static electric oven - 1200mm. Gp [1] 8121gec gas griddle range convection ele...
Page 6
4 specifications gas supply requirements - australia / new zealand only: - uk only: appliance classification category: ii 2h3p. Flue type: a 1. * the burner operating pressure is to be measured at the gas control valve outlet test point (refer to fig 2) with one griddle burner operating at 'high' se...
Page 7
5 specifications electrical supply requirements electrical connection gp8910ge / gec electrical supply connection point is located at the rear of the appliance, approximately 80 mm from the right hand side and 466 mm from the rear and 150 mm from the floor. Gp8121ge / gec electrical supply connectio...
Page 8
6 dimensions gp[l]8910ge / gec gp[l]8121ge / gec.
Page 9
7 installation requirements note: • it is most important that this appliance is installed correctly and that operation is correct before use. Installation shall comply with local gas, electrical and health and safety requirements. • this appliance shall be installed with sufficient ventilation to pr...
Page 10
8 clearances note: only non-combustible materials can be used in close proximity to this appliance. Assembly this model is delivered completely assembled. Ensure that the legs are securely attached. Note: • this appliance is fitted with adjustable feet to enable it to be positioned securely and leve...
Page 11
9 gas connection note: all gas fitting must only be carried out by an qualified person. 1. It is essential that the gas supply is correct for the appliance to be installed and that adequate supply pressure and volume are available. The following checks should therefore be made before installation:- ...
Page 12
10 installation electrical connection note: all electrical connections must only be carried out by an qualified person. Each appliance should be connected to an adequately protected power supply and isolation switch mounted adjacent to, but not behind the appliance. This switch must be clearly marke...
Page 13
11 installation commissioning before leaving the new installation; check the following functions in accordance with the operating instructions specified in the ‘operation’ section of this manual. • light the griddle pilot burner. • light the griddle main burner. • check the griddle low fire operatio...
Page 14
12 operation operation guide 1. Waldorf gas griddle range electric oven have been designed to provide simplicity of operation and 100% safety protection. 2. Improper operation is therefore almost impossible, however bad operation practices can reduce the life of the appliance and produce a poor qual...
Page 15
13 operation lighting the griddle - pilots these griddles are fitted with a pilot as a standard option and flame failure protection, which is incorporated by way of a thermo-electric system for each main burner. Flame failure protection will shut off the gas supply to that burner in the event that t...
Page 16
14 operation turning 'off' the griddle main burner / pilot 1. Turn the gas control knob clockwise to the pilot position. The main burner will extinguish and the pilot burner will remain alight. 2. To turn 'off' the appliance completely, turn the gas control knob fully clockwise to the 'o' position, ...
Page 17
15 cleaning and maintenance general clean the range regularly. A clean range looks better, will last longer and will perform better. Carbonised grease on the surface or on the griddle plate will hinder the transfer of heat from the cooking surface to the food. This will result in loss of cooking eff...
Page 18
16 cleaning and maintenance daily cleaning 1. The grease drawer should be checked and emptied frequently to prevent overflow and spillage. Remove the grease drawer while still warm so that the grease is in a liquid state. Empty any grease from the drawer and wash thoroughly in the same manner as any...
Page 19
17 cleaning and maintenance stainless steel surfaces a. Clean the exterior surfaces of the range with hot water, a mild detergent solution and a soft scrubbing brush. Note that the gas control knobs are a push fit onto the gas control valve spindles and can be removed to allow cleaning of the front ...
Page 20
18 fault finding this section provides an easy reference guide to the more common problems that may occur during the operation of your appliance. The fault finding guide in this section is intended to help you correct, or at least accurately diagnose problems with your equipment. Although this secti...
Page 21
19 gp8910ge and gp8121ge wiring schematics.
Page 22
20 wiring schematics wiring diagram: gp8910ge gp8121ge.
Page 23
21 gp8910gec and gp8121gec wiring schematics.
Page 24
22 wiring schematics wiring diagram: gp8910gec gp8121gec.
Page 25
23 gas conversion and specifications conversion procedure note: • these conversions should only be carried out by qualified persons. All connections must be checked for leaks before re-commissioning the appliance. • adjustment of components that have adjustments / settings sealed (e.G. Paint sealed)...
Page 26
24 gas conversion and specifications 8. Refit the front control panel and tighten the 2 screws on the underside to secure the panel in place. 9. Refit the control knobs to the front control panel. The control knobs are a push fit onto the shafts of the gas control valves. Low fire adjustment - (gas ...
Page 27
25 gas conversion and specifications gas regulator note: the regulator supplied is convertible between natural gas and lpg, but it’s outlet pressure is fixed ex-factory and is not to be adjusted. 1. Ensure that the gas supply is turned ‘off’ at the mains. 2. Unscrew the hexagonal cap (23mm a/f) from...
Page 28
26 gas conversion and specifications commissioning before leaving the converted installation; 1. Check all gas connections for leakages using soapy water or other gas detecting equipment. 2. Check the following functions in accordance with the operating instructions specified in the ‘operation’ sect...
Page 29
27 gas conversion and specifications gas specifications - australia / new zealand only - uk only appliance classification category: ii 2h3p. Flue type: a 1. Note 1 the gas control valve is fitted with a maximum flow bypass blanking screw, non adjustable. Note 2 the burner operating pressure is to be...
Page 30
28 replacement parts list when ordering replacement parts, please quote the part number and the description as listed below. If the part required is not listed below, request the part by description and quote model number and serial number which is shown on the rating plate. Griddle controls 227443 ...
Page 31
29 general 227892 oven side rack lh. 227893 oven side rack rh. 227896 oven rack. 228400 grease drawer. 227850 adjustable legs. 229674 rear roller assy. Griddle plate options accessories 228566 griddle scraper tool. 228567 smooth plate scraper blades (pack of 5 blades). 233817 ribbed plate scraper bl...
Page 32
30