- DL manuals
- Waldorf
- Toaster
- GT8600G
- Installation And Operation Manual
Waldorf GT8600G Installation And Operation Manual
Summary of GT8600G
Page 1
I n s t a l l a t i o n a n d o p e r a t i o n m a n u a l gt8600g date purchased serial number dealer service provider gas griddle toaster 228002-15 for use in gb & ie.
Page 2
Manufactured by moffat limited christchurch new zealand international contacts australia moffat pty limited web: www.Moffat.Com.Au e.Mail: vsales@moffat.Com.Au main office: (tel) +61 (03) 9518 3888 (fax) +61 (03) 9518 3833 service: (tel): 1800 622 216 spares: (tel): 1800 337 963 customer service: (t...
Page 3
Contents waldorf gas griddle toaster gt8600g introduction ................................................................................................ 2 specifications .............................................................................................. 3 model numbers covered in this s...
Page 4
2 introduction we are confident that you will be delighted with your waldorf gas griddle toaster, and it will become a most valued appliance in your commercial kitchen. To ensure you receive the utmost benefit from your new appliance, there are two important things you can do. Firstly please read th...
Page 5
3 specifications model numbers covered in this specification gt8600g gas griddle toaster general a commercial heavy-duty gas fired griddle toaster, having two tubular burners heating a griddle plate from underneath and providing toasting heat for the toasting rack below. Burners are operated by indi...
Page 6
4 specifications - all other markets: (*) note: measure burner operating pressure at manifold test point with two burners operating at 'high flame' setting. Nat, lpg & butane only - operating pressure is ex-factory set and is not to be adjusted, unless when converting between gases, if required. Tow...
Page 7
5 dimensions gt8600g weight (nett) gt8600g 120kg gas connection point..
Page 8
6 installation installation requirements note: it is most important that this appliance is installed correctly and that operation is correct before use. Installation shall comply with local, gas, health and safety requirements. This appliance shall be installed with sufficient ventilation to prevent...
Page 9
7 installation 5. Components having adjustments protected (e.G. Paint sealed) by manufacturer are only to be adjusted by a qualified service agent. They are not to be adjusted by the installation person. Note: do not obstruct or block appliances flue. Never directly connect a ventilation system to a...
Page 10
8 installation gas connection note: all gas fitting must be carried out by a qualified service person. 1. Waldorf gas griddle toasters do not require an electrical connection, as they function totally on gas supply only. 2. It is essential that gas supply is correct for appliance being installed and...
Page 11
9 installation note: measure burner operating pressure at manifold test point with both burners operating at ‘full’ setting. 8. Verify operating pressure remains correct. Commissioning 1. Before leaving the new installation; a. Check the following functions in accordance with operating instructions ...
Page 12
10 operation operation guide 1. Waldorf gas griddle toasters have been designed to provide simplicity of operation and 100% safety protection. 2. Improper operation is almost impossible, however, bad operation practices can reduce the life of the appliance and produce a poor quality product. To use ...
Page 13
11 operation lighting pilot burners 1. Depress gas control knob and rotate anti-clockwise to ‘pilot’ position. 2. With control knob depressed, press piezo ignition button until pilot burner ignites. Pilot ignition can be viewed through openings in control panel. 3. Hold in gas control knob for appro...
Page 14
12 cleaning and maintenance general clean the griddle toaster regularly. A clean appliance looks better, will last longer and will perform better. Carbonised grease on surface or on griddle plate will hinder transfer of heat from cooking surface to food. This will result in loss of cooking efficienc...
Page 15
13 cleaning and maintenance daily cleaning 1. Crumb tray / grease drawer should be checked and emptied frequently to prevent overflow and spillage. Remove grease drawer while still warm so that grease is in a liquid state. Empty any grease from drawer and wash thoroughly in same manner as any cookin...
Page 16
14 cleaning and maintenance stainless steel surfaces a. Clean exterior surfaces of griddle toaster with hot water, a mild detergent solution and a soft scrubbing brush. Note that gas control knobs are a push fit onto gas control valve spindles and can be removed to clean front of control panel. B. B...
Page 17
15 fault finding fault possible cause remedy pilot won’t light. No gas supply. Blocked pilot injector. Ensure gas isolation valve is turned on, and bottles are not empty. Call service provider. Pilot goes out when gas control knob released. Releasing knob before thermocouple has heated. Pilot flame ...
Page 18
16 gas conversion and specifications conversion procedure note: these conversions should only be carried out by qualified persons. All connections must be checked for leaks before re-commissioning the appliance. Adjustment of components that have adjustments / settings sealed (e.G. Paint sealed) can...
Page 19
17 gas conversion and specifications gas regulator nat gas / lpg / butane only. Note: the gas regulator supplied is convertible between natural gas and lp gas, but it’s outlet pressure is fixed ex-factory and is not to be adjusted. - town gas only. 1. Remove slotted cap from regulator. 2. Turn ‘on’ ...
Page 20
18 gas conversion and specifications gas specifications - australia: - new zealand: - uk only category: ii 2h3p (20, 30 / 37). Flue type: a 1. Note: * - measure burner operating pressure at manifold test point with both burners operating at full setting. Operating pressure is ex-factory set, through...
Page 21
19 gas conversion and specifications - all other markets: (*) note: measure burner operating pressure at manifold test point with both burners operating at 'high flame' setting. Nat, lpg & butane only - operating pressure is ex-factory set and is not to be adjusted, unless when converting between ga...
Page 22
20 replacement parts list replacement part list when ordering replacement parts, please quote the part number and the description as listed below. If the part required is not listed below, request the part by description and quote the model and serial number which is on the rating plate. Controls 23...
Page 23
21 replacement parts list accessories 228795 plinth kit - 600mm. 228566 griddle scraper tool. 228567 smooth plate scraper blades (pack of 5 blades). Gas conversion kits model gas type to convert to nat. Gas lpg (propane) butane town gas gt8600g 231980 231979 231981 232013.