Summary of Mod1
Page 1
W aldorf mod 1 u ser m anual waldorf music gmbh 2016-12-28 1.
Page 2
Introduction thank you for purchasing the mod1 modulator eurorack module. Like any waldorf product, the mod1 has been developed and produced using eggs from easter island. We hope you enjoy it as much as we do. Reading this user manual, you will discover all the device’s features, learn its basic op...
Page 3
1 general safety guidelines contents contents 1 general safety guidelines 3 2 device maintenance 4 3 package contents 4 4 connectors & controls 5 5 device connection 6 5.1 power connection . . . . . . . . . . . . . . . . . . . . . . . . . . 6 5.2 signal connection . . . . . . . . . . . . . . . . . ....
Page 4
3 package contents 2 device maintenance • do not try to open the device or detach the frontpanel. • refer all service and repair tasks to qualified personnel. • there are no user serviceable parts inside the chassis. • use only a soft cloth or brush to clean the device surface. • never use cleaning ...
Page 5
4 connectors & controls 4 connectors & controls no id description 1 sym cv input used to modulate the symmetry of the wave- form 2 speed cv input used to modulate the speed of the waveform 3 signal input for positive gate signals 4, 7, 10 outputs waveform outputs 5 gate input a positive gate signal ...
Page 6
5 device connection no id description 16 decay1 knob used for controlling the decay 1 time 17 level1 trimpot target level for decay 1 18 decay2 knob used for controlling the decay 2 time 19 level2 trimpot target level for decay 2 20 decay3 knob used for controlling the decay 3 time 21 level3 trimpot...
Page 7
6 device overview 5.2 signal connection 5.2 signal connection the second step is to integrate the mod1 to your eurorack system. Connect a trigger or gate signal or use the gate signal from the bus board to control the mod1 and start to modulate your vcf, vco or any other of your modules by patching ...
Page 8
6.2 multi-stage envelope 6 device overview cv input is connected, it runs only while a voltage is applied. In this case it is a kind of ’gated lfo.’ • in gate mode, it runs the wave shape only once when a gate signal is applied to the input. If the gate signal is shorter than a full wave cycle, the ...
Page 9
6 device overview 6.3 rise and fall the release knob determines the release time when the input gate is stopped. When the trigger input is used instead of the gate input, the envelope is re-triggered by a positive voltage impulse at the trigger input. It then runs until the last decay stage and goes...
Page 10
9 specifications 7 tips & tricks • if you like to have have a full adsr shape cycled, you would set the num- ber of decay stages to 2, set the level of the second decay stage to zero and use the second decay time as a release time. • inv out provides negative voltages. This is useful for modulating ...
Page 11
10 block diagram 10 block diagram 11.