1 copy of instruction manual daylight 450 gewerbering 26 86666 burgheim tel. +49 84 32 / 9489-0 fax. +49 84 32 / 9489 - 8333 email: info@foto-walser.De www.Foto-walser.De.
2 content 1. How to understand the instruction manual................................... 4 1.1 markings on the device ..................................................................... 4 1.2 markings in the manual ..................................................................... 4 2. Importan...
3 thank you very much for your confidence. We wish you much pleasure and success with your studio flash. The walimex daylight 450 is a powerful, energy-saving continuous light, which is especially developed for ambitious beginners and professional users in film and studio photography. The main featu...
4 1. How to understand the instruction manual 1.1 markings on the device this marking mean, that your device meets the safety requirements of all relevant european directives. This marking mean, that your device should be disposed in the local disposal points. 1.2 markings in the manual marking mean...
16 3. Open fuse holder: use a small screwdriver to lift up the fuse holder carefully and slightly. 4. Pull out the fuse holder with your hands completely out of the slot. 5. Take out the old micro-fuse. 6. Take the new micro-fuse out of the spare slot and slide it into the center of the holder. 7. S...
6 humidity or moisture. A short-circuit can warm up the conductors, so that there isolation will melt or even melt thoroughly. This could lead to fire. − please just use the original cables, which are included in delivery. They are aligned for your device and guarantee the necessary safety for you a...
14 10. Maintenance 10.1 continuous inspections what you should do? Before every operation with every change check all cables and plugs for damages. In case of damage: warning! Danger of electric shock and fire through short-circuit. The device should be repaired by an electrician immediately. X chec...
8 − please handle the lamps with care to avoid bursting. − don´t touch the lamps with bare hands. Just touch the lamp at the plastic socket or wear clean cotton gloves or use a clean cloth. − avoid touching the flash tube accidentally when mounting or changing accessories. − please just use lamps, w...
12 7. Operation of the device 7.1 adjust tilt angle 1. Open tilt lever. 2. Adjust the required tilt angle. 3. Tighten tilt lever. 7.2 switch the device on and off the lamps can be switched on and off flexibly through the three tappet switches on the operation panel. 1. Switch on device and lamp: set...
10 5. Quick start guide advice: the detailed instruction for the following operations can be found in the respective chapters in this instruction manual. Keep the sequences of the following operation steps when using the device for the first time to avoid damages on the device. Warning please note t...
