Walker Bay WB 10F Owner's Safety Manual & Assembly Instructions - Assembly Instructions
ASSEMBLY INSTRUCTIONS
- WALKER BAY 10
- WB 10F
1
Step
2
Step
3
Step
C
B
A
B
D
E
The drain plug included with your
Walker Bay is not self bailing.
The drain must be securely plugged
with the bung before launching boat.
To avoid leaking, make sure rubber gasket
is installed correctly and bolts are tight.
PARTS LIST
Boat and seats packed separately, some assembly required.
Safety and Conformity Assessment Certification only applicable if
assembly instructions are followed correctly.
Description
A.
Wheel Assembly
B.
Screw (#14 x 1”) x 8
C.
Keel Plate
D.
Bow Eye Assembly
E.
Drain Plug Assembly
F.
Bow Seat
G.
Mid Seat
H.
Rear Seat
I.
Bolt (1/4”-20 x 1-1/4”) x 16
J.
Washer (1/4”) x 22
K.
Nut Cone x 18
L.
Nyloc Nut x 22
M.
Mast Cap
N.
Dagger Cap
O.
Bolt (1/4”-20 x 1-1/2”) x 6
P.
Motor Mount
Floor
Q.
Front Corner Blocks
R.
Bolt (1/4”-20 x 1-1/2”) x 2
S.
Hex Nut x 2
T.
Locking Washer x 2
U.
Non Skid Floor w/Pads
V.
Rear Corner Blocks
W.
Rowing Foot Rest
Tools Required for Assembly:
1.
Nut Driver, 7/16” (included)
2.
Screw Driver, Phillips (not included)
Specifications and contents subject to change without notice.
4
Step
Remove and
discard skid
plate.
Page 10
6
Step
7a
Step
7b
Step
7c
Step
5
Step
N
B
M
I
J
K
L
F
G
H
I
J
I
J