Walkera -- ff$-- @&w@ user manual note: please read the manual thoroughly before using and keep it in a safe place for future reference. Welcome to the devo 4 transmitter.
Content part one: general information 1.0 foreword------------------------- ----------· 1 1.1 important statements - - - - - - - - - - - - - - - - - - - - - - - - - · 1 1.2 safety guidelines needing attention - - - - - - - - - - - - - - · 1 1 .3 attention before flight - - - - - - - - - - - - - - - ...
Part one: general information 1.0 foreword the devo-4 is 4 channel micro computer system,it uses 2.4 ghz direct sequence spread spectrum (dsss) technology, supports automatic id binding and assignment, is small in size and easy to use. 1.1 important statements (1) the transmitter is suitable for exp...
(3) proper operation please use original walkera spare parts to upgrade, modify or maintain your equipment in order to assure its safety. Please operate your equipment within the range of the permitted functions. Ii is forbidden to operate this equipment outside of the safety laws and regulations of...
2. 0 dev0-4 transmitter features (1) the devo-4 uses 2.4 ghz direct sequence spread spectrum (dsss) technology. (2) supports automatic id binding and assignment. (3) 4 channel micro computer control system. (4) type hidden reverse switch setting. (5) d/r switch one butten change. (6) low voltage ala...
4.0 definition of dev0-4 4.1 front panel view elevator/ rudder------- stick --------throttle i aileron stick 4.
4.2 wiring diagram: antenna devo-rx601 receiver antenna 4.8v battery d ; power switch charge jack 5 elevator servo aileron servo throttle servo rudder servo.
5.0 neck strap usage there is a concealed eyelet in the front panel of the devo-4. It will pop out when you press the eyelet. The neck strap hook can then be connected to the eyelet. This eyelet is located near the center of gravity which helps to obtain the optimal balance for the transmitter. Neck...
7.0 installation requirement for dev0-4 battery pack open the batte ry cover of dev0-4 transmitter and take out the battery box. Insert 4 new aa batteries either alkaline or full charged nimh battery into the battery box. Please double check the polarities are correct and do not mix old and new batt...
Party two: function setup 1.0 reverse switch we provide a reversing switch for each channel, see below: open the flexible cover on the back of the transmitter, there are 4 switches, switch to on according to mark on the cover. Replace the flexible cover once you have finished. Rubber cover 2.0 dual ...
walkera product the specifications of the ric product may be altered without notice. :a:- -.
