1. DL manuals
  2. Walkera
  3. Toy
  4. HM 5#10 helicopter
  5. Instruction Manual

Walkera HM 5#10 helicopter Instruction Manual

Summary of HM 5#10 helicopter

  • Page 1

    Instruction manual specifications: main rotor diameter a: 340mm drive system: 2x 130ph all-up weight: 188g (battery included) main rotor diameter b: 340mm transmitter: wk-0408 battery: 3.7v 1000mah li-po overall length: 425mm receiver: rx-410 (4-in-1 receiver) gyro: built-in servos: weight 8.5g / sp...

  • Page 2: Contents

    2 contents introduction ------------------------------------------------------------------------------ 3 warnings --------------------------------------------------------------------------------- 3 cautions ---------------------------------------------------------------------------------- 4 charging...

  • Page 3: Introduction

    3 introduction thank you for purchasing our product. We strongly recommend that you read the whole user manual before you fly your helicopter. This will make it easier and safer as you will be given a full explanation of how the helicopter works, and how to use the control transmitter. Keep the manu...

  • Page 4: Cautions

    4 cautions 1. This helicopter is operated by radio control, so it is important that you are always using fresh and / or fully charged batteries. Never allow the batteries to run low as that may cause you to lose control of the helicopter. 2. Always turn on the transmitter before plugging in the flig...

  • Page 5

    5 1. Charging on-board li-po batteries:  use the supplied battery charger for the on- board li-po battery in the helicopter. This charger will automatically give the correct charge.  plug the charger to the battery before plugging the charger into power point if the power point is not switched off...

  • Page 6: Transmitter Features

    6 transmitter features 4-channel transmitter features: 1. The transmitter has power indicator, ergonometric design, and dip switches available for servo reversing. 2. 4-channel micro-computer encoder; ppm modulation; output power 200mw; current drain: 150ma; 3. Power source: 8 x 1.2v ni-cd battery (...

  • Page 7: Receiver Identification

    7 dip switches identification (fig. 3): 1. Elevator. Reverse the elevator servo direction. 2. Aileron. Reverse the aileron servo direction. 3. Throttle. Reverse the throttle stick direction. Note: make sure that the throttle stick works correctly before flight, 4. Rudder. Reverse the rudder stick di...

  • Page 8: Swashplate Adjustment

    8 swashplate adjustment 1. Swashplate inspection. Pull down the throttle stick and throttle trim to the lowest position, and put the elevator trim and aileron trim in the neutral position, - centred (fig. 1). Then turn on the transmitter and then connect the helicopter power cable. Check whether or ...

  • Page 9

    9 flying hm 5g4 if you are new to flying model helicopters, please read and follow these instructions: first make sure that all your batteries are fully charged, and that there is nothing around you that may create interference for the receiver. Check that the helicopter is balanced by putting a fin...

  • Page 10

    10 flying the mh 5g4 in mode 1 for mode 2 the elevator and the throttle are on opposite side of mode 1. The trims are also changed over accordingly. See next page >.

  • Page 11

    11 flying the mh 5g4 in mode 2.

  • Page 12

    12 notice: the specifications of this r/c helicopter may change without prior notice..