1. DL manuals
  2. Walkera
  3. Toy
  4. V450D01
  5. User Manual

Walkera V450D01 User Manual

Other manuals for V450D01: User Handbook Manual
Manual is about: radio control aircraft model

Summary of V450D01

  • Page 1

    1 user guide - supplemental c ontents 5 instructions for rx2702v receiver .................................................................................................................. 2 5.3 channel connection of receiver .............................................................................

  • Page 2

    2 5 i nstructions for rx2702v receiver 5.3 c hannel connection of receiver ( for mode 2 users only ?) caution: please note that when using a mode 2 transmitter set-up pit and aile servos are inverted compared to the original manual. There are 2 options to correct this: 1) physically move the servos ...

  • Page 3

    3 10 w alkera v450d01 f lybarless s ystem s etting rx2702v 10.5 f lybarless system setting caution: unplug the wires connecting the esc to the main motor to avoid the accidental movement of the main rotor. Reconnect when set-up is complete. Prior to this section it is recommended to make a copy of t...

  • Page 4

    4 step 4: main blade pitch setting the recommended pitch range is ±10°; the flight limit is ±11°. Caution: the adjustment of servo travel in a ccpm system must be made using the transmitter ‘swashmix’ function, do not adjust the servo travel individually. 10.5.2 s washplate mixing set - up for e lev...

  • Page 5

    5 step 3: swashplate aileron travel setting with the aile led flashing green the receiver is ready to accept the maximum limit of aile input. Without moving any of the other controls push the aileron control stick of the transmitter to the far right position, while keeping max aile, press the “set” ...

  • Page 6

    6 10.5.3 e levator and aileron gyro function normal / reverse setting step 1: elevator gyro reverse switch setting tilt the helicopter forward and check if the gyro corrects the motion by tilting the swashplate aft. If it tilts to the front move the elev gyro dip switch to the other position. Re-che...

  • Page 7

    7 to check the correct operation of the rudder direction move the rudder stick on the transmitter left and right. Full right rudder should set the pitch of the tail blades to move the tail left and the nose right as it rotates about the main shaft axis. Step 3: enter rudder servo travel set-up mode ...

  • Page 8

    8 10.5.6 f lybarless system setting test step 1: make sure everything is off and all receiver leads are connected. Make sure main motor leads are still disconnected step 2: turn on the transmitter power and connect the helicopter main battery, wait for binding to complete. During this the swashplate...