Wallas 85DU w/270 Lid Installation And Start-up Manual

Summary of 85DU w/270 Lid

  • Page 1

    Initial installation and start-up tips wallas 85 du & dp cooktop the 85 series wallas cook-top is the third generation of cooking devices from this finnish company. Starting in 1995, wallas introduced a #2 diesel fueled cook-top called the model 95d, designed primarily for the north american market....

  • Page 2

    In most cases the 85d has been sold in north america fitted with the 270 blower lid, a significant improvement over the 25 lid, with variable blower speed to match combustion power level. Both the 95 and 85 have been made available in du (flush mounted) and dp (countertop mounted) versions. The dp m...

  • Page 3

    After installation and before start-up 1. Make sure the black connect cable from the controller to the front of the cook-top under the counter on the du model, “clicks” into position on both the controller and the cook-top. 2. Make sure the red and black power cable with the white plug is fully inse...

  • Page 4

    I. Pushing the start switch to “on” will trigger an alternating red and yellow flashing, changing to a “steady” yellow in a few seconds. During this initial flashing the unit is doing a self test to insure all critical components are in working order. The steady yellow means that voltage at the unit...

  • Page 5

    Begun the fuel pump will start pulsing (making a subtly “clicking” sound) and fuel will start to travel from the fuel tank towards the cook-top. The start cycle is timed to about 5 minutes. If the fuel does not reach the inside of the combustion chamber in that time period, the red light will start ...

  • Page 6

    3. Make sure that the fuel pump is actually “clicking” starting at the 35 to 90 second point after starting. If you can’t hear the clicking, put your thumb and forefinger on the fuel line to fuel pump connection, you should feel a “pulse”, much like a human pulse at about 30 beats per minute. A. If ...

  • Page 7

    Problem: “i have a flickering yellow light and the unit won’t do anything.” solution: the control panel has determined that the voltage is insufficient for starting. Check all the power wire connections all along the main power leads and inside the cage on the du model. Test for voltage at the unit ...