Operating instructions model cg-600l cordless caulking gun.
1. The appliance is not intended for use by young children or infirmed persons unless they have been adequately trained by a responsible adult to ensure that they can use the appliance safely and without supervision. 2. Young children should be supervised to ensure that they do not play with the app...
1. Caution: to reduce risk of injury, change only specific type rechargeable batteries. Other types of batteries may burst causing personal injury and damage. 2. Before using battery charger, read all instructions and cautionary markings on the batteries and chargers. 3. Do not expose charger to rai...
View of the major components & accessories model no cg-600l voltage 10.8v dc capacity 600ml expel force 392kgf impacts per minute 3000 tool weight (with battery) 2.335kg (battery 0.185kg) no load speed 6.1mm/sec charging time 35 minutes – auto cut-off performance 45 tubes of 225mm (9”) silicone for ...
Operating instructions installing or removing battery pack (see fig.1 fig.2 ) 1. Always switch off the machine before insertion or removal of the battery pack. 2. To remove the battery pack, pull out the set plate on the machine and grasp both sides of the battery pack while withdrawing it from the ...
The led light on the charger power on (green light flashes slowly) batterylow(redlightstaysilluminated) battery charged 80% (green light flashes rapidly) battery charged 100% (green light stays illuminated) batterypacktemperatureistoohotortoocold(redlightflashesslowly) batterypackmalfunction(redandg...
Tool operation – for sausage bag application 1. Cut a hole in one end of the sausage bag as shown in the figure below. 2. Removethefrontcap.Fitthenozzleinsidethefrontcapandcutoffthetipatapointsuitableforthe job. 3. Insert the sausage bag into the compound holder. Screw the front cap on tight. It is ...
Tool operation – for cartridge application 1. Loosen and remove compound holder. 2. Loosen m8 screw then remove the plastic plunger disk. Rack plunger disk front cap compound holder plastic plunger disk rack plunger disk m8x16 screw.
5. Use a sharp knife to cut the tip of caulking tube at least 3 mm in diameter. This will allow the tool to provide a optima seam width for most of applications. 6. Use the sharp tip to jab the aluminum seal on the caulking tube. 7. If you are using a previously opened tube, use a steel wire to remo...
Parts & assembly no. Partsname cg6-1 front cap cg6-2 compound holder cg6-3 plunger screw cg6-4 c-ring cg6-5 plunger disk brush cg6-6 plastic plunger disk cg6-7 plunger disk cg6-8 spring cg6-9 plunger adaptor screw cg6-10 connectionringscrew cg6-11 connector cg6-12 fixed cap screw cg6-13 connecting c...
Warranty wallboard tool co pty ltd warrants that this product will be free from any defect in materials or workmanship for twelve (12) months from your purchase date (noted on your invoice or receipt). At its discretion, wallboard tool co pty ltd will either repair or replace your product, if it is ...
Customer service 1300 653 177.
