Operating instructions cordless impact driver model id-3000l.
1. The appliance is not intended for use by young children or infirmed persons unless they have been adequately trained by a responsible adult to ensure that they can use the appliance safely and without supervision. 2. Young children should be supervised to ensure that they do not play with the app...
1. Caution: to reduce risk of injury, change only specific type rechargeable batteries. Other types of batteries may burst causing personal injury and damage. 2. Before using battery charger, read all instructions and cautionary markings on the batteries and chargers. 3. Do not expose charger to rai...
Model no id-3000l voltage 14.4v dc no load speed 0-2000rpm max torque 2000kg/cm impacts per minute 3000 tool weight (with battery) 1.53kg (battery 0.53kg) capacity 6mm/10mm charging time 1 hour – auto cut-off specifications.
View of the major components & accessories forward/reverse rod battery pack main switch battery knob bit holder belt hook screw belt hook charger.
Operating instructions (slide-in) installing or removing battery pack (see fig.1 fig.2 ) 1. Always switch off the machine before insertion or removal of the battery pack. 2. To remove the battery pack, push the button on the battery pack and pull the tool unit from the battery pack in the direction ...
The led light on the charger power on (green light flashes slowly) battery low (red light stays illuminated) battery charged 80% (green light flashes rapidly) battery charged 100% (green light stays illuminated) battery pack temperature is too hot or too cold (red light flashes slowly) battery pack ...
Installing or removing bit 1. To install the bit, pull the retainer in the direction of the arrow and insert the bit into the retainer as far as it will go. Then release the retainer to secure the bit (see fig.1). 2. To remove the bit, pull the retainer in the direction of the arrow and pull the bit...
Installing or removing belt hook 1. Installing hook: use t20 size bit and tighten in clockwise. 2. Removing hook: use t20 size bit to loosen the hook. Fig. 1 fig. 2 replaceable carbon brush 1. Replace the new carbon brush, while the motor is not rotated and the carbon brush is run out. (change the n...
Parts & assembly no. Parts name qty 1 front cover & front impact assembly 1 2 rear impact ass’y 1 3 washer 1 4 ring gear 1 5 bearing 1 6 screw 2 7 ring gear steady 1 8 rubber washer 1 9 motor assembly 1 10 carbon brush 2 11 housing back cover assembly 1 no. Parts name qty 12 led 1 13 main switch 1 1...
Model id-3000l warranty wallboard tool co pty ltd warrants that this product will be free from any defect in materials or workmanship for twelve (12) months from your purchase date (noted on your invoice or receipt). At its discretion, wallboard tool co pty ltd will either repair or replace your pro...
Customer service 1300 653 177.
