Walrus Audio Phoenix Instruction Manual
PHOENIX POWER SUPPLY
INSTRUCTION MANUAL
The Walrus Audio PHOENIX is a 15-Output isolated
power supply, utilizing an two internal custom
wound toroidal transformers to provide the highest
noise filtering and cleanest power, giving artists the
purest sound in their signal chain. The PHOENIX is
housed in a solid die cast enclosure and is 9.75”
long x 2.6” wide x 2” high and has the following
outputs available:
The PHOENIX features 300 mA high current
outputs are for higher current drawing pedals like
line Strymon BigSky and TimeLine, the Boss Twin
Series Pedals, and many digital modulation
pedals on the market. It comes with a detachable
230V IEC Cable. This unit comes with 15 – 2.1mm
barrel black power cables.
OPERATING INSTRUCTIONS
Plug in the 230VAC power cord to the 230VAC
input. Plug the Male end of the power cord into a
230VAC power source (230VAC only – this
product is not rated for any other voltages). Once
plugged in, the blue LED will light up indicating
that the power supply is on. Warning! Before
connecting your effects pedal to the PHOENIX,
you must first verify the power requirements of
your pedal.
(x15)
2.1mm – Standard for
Most Effects Pedals
VOLTAGE RATING
The voltage rating for of your pedal must be 9VDC
(direct current), do not use the PHOENIX for AC
(alternating current) pedals. Most effects pedals are
designed for 9VDC power, however, you should
always check first or you could risk destroying your
pedal. For other voltages, like 15VDC or 24VDC,
which are common, you will need to use a custom
power supply that the manufacturer provides or
recommends.
8 - 9V 100mA
4 - 9V 300mA
1 - 18V/9V 100mA
2 - 12V/9V 100mA
9V - 100mA
18V/9V 100mA
9V - 100mA
12V/9V 100mA
No user serviceable parts inside.
Do not remove cover, risk of electrical shock.
Warranty is voided if backplate is removed.
CAUTION
(x2) Red-to-Black
2.1mm – Reverse Polarity
for Line 6 Effects Pedals
18V/9V
12V/9V
230VAC European IEC power cord
9V - 300mA
9V - 300mA