Walser 16000 Instructions For Use Manual - page 2
11
DE
Drahtlose Rückfahrkamera und Monitor
Sehr geehrter Kunde,
herzlichen Glückwunsch. Die drahtlose Rückfahrkamera & Monitor wird, wenn sie wie hier be-
schrieben verwendet wird, Ihre Sehfähigkeit hinter Ihrem Auto, Lastwagen, RV oder Mini-Van um einiges verbessern. Wir haben
vielzählige Maßnahmen in der Qualitätskontrolle durchgeführt, um sicherzustellen dass das Produkt wenn es Sie erreicht in
höchster Qualität sein, sowie zu Ihrer vollsten Zufriedenheit funktionieren wird.
VoR DER InStallatIon
Die Installation von Videozubehör kann auch für die erfahrensten Techniker manchmal schwierig sein. Wenn Sie sich mit den
Arbeiten mit 12 Volt DC Verkabelungen, entfernen oder installieren von Verdeckungen, Bodenbelaege, Faecher oder anderen
Komponenten Ihres Fahrzeugs nicht sicher sind, dann kontaktieren Sie bitte den Fahrzeughersteller oder bitten Sie eine profes-
sionelle Werkstätte dies zu tun.
Dieses Gerät, sowie andere drahtlose Geräte, können von mobilen Telefonen, Bluetooth Headsets, Wi-Fi Stationen,
Strom Kabel oder anderen elektrischen Geräten beeinflusst werden.
Das betreiben des Produkts folgt folgenden Konditionen:
(1) Dieses Gerät hat keinen schädlichen Einfluss auf den Menschen und
(2) Dieses Gerät muss Einwirkungen von außen standhalten
tEIlE
1. Monitor & Montage-Arm
2. Kamera mit Montage Rahmen inkl. Nacht-Sicht
3. Funksender Gehäuse
4. Monitor Kabel
5. Funksender Gehäuse Strom-Kabel
2
MEnU, + and – Buttons
Press
MEnU
button to enter the menu screen as shown below:
Repeat pressing
MEnU
button to select BRIGHTNESS,
CONTRAST or COLOR controls. Press + button or – button
to adjust settings within the control selected. Press the + button to increase the value and
the – button to decrease the value.
To change the orientation of the screen image, press MENU button until DIRECTION
is selected. Then press + or – repeatedly until desired screen orientation “left to right
down” is achieved.
The different views allow you to mount the camera and / or monitor either right side up or upside down and still display the image
correctly on the monitor. The image displayed should match your rear view mirror. To exit the menu screen, select EXIT on the
screen using the MENU button and press either + or – to exit the menu screen.
Guideline on/oFF
Press GUIDELINE ON/OFF button to switch ON or OFF the on-screen-display guideline.
tEStInG tHE SYStEM
1. Reattach the vehicle’s negative battery cable.
2. Turn the ignition key to the accessory position, do not start the vehicle.
3. Engage the parking brake, put the shifter in the reverse position.
4. Turn the monitor ON by pressing the ON/OFF button on the monitor.
5. Look at the monitor, if the image does not match your rear view mirror press the Image Orientation button on the monitor to
correct the image.
After testing the unit and you are satisfied with the route you have chosen for the cabling, you must permanently install it. Fully
tighten the license plate bolts.
Route all wires behind interior panels or under carpeting so they are hidden.
Use supplied cable ties to neatly gather any excess wire.
ClEanInG
We kindly ask you for a regularly cleaning of the camera lenses and the LED lamps with a soft cloth.
DISPoSal
Please dispose the camera as controlled waste only at places for recycling of electrical and electronic hardware.