Walther MPP-02 Assembly Instructions Manual - page 20
Rev. 1.2
Assembly Instructions - MPP-02 Micro Point Pulse Valve
Page 20 of 20
Walther Systemtechnik GmbH
– D 76726 Germersheim
phone: +49 (0)7274-7022-0 fax: +49 (0)7274-7022-91
http://www.walther-2000.de
– info@walther-2000.de
10.6.1 Add-on elements
Sensor for Raster Needle
The installation of a sensor for raster needle is factory-made. It is integrated in the raster needle lock (pos.
7.0 of spare parts list). As a spare part, the raster needle lock is always delivered as a complete unit, since
the initiator is factory-adjusted and pasted in.
Pos.
Description
1
Sensor for raster needle
Pressure Sensor
The attachment of a pressure sensor is also factory-made. Its position can optionally be on the side (left /
right) or on top. For additional information please refer to the Asse,bly Instructions
“Pressure Sensors 97PA-
21x-xxx
“.
Pos.
Description
2
Pressure sensor mounted on the left of the pulse valve
3
Pressure sensor mounted on top of the pulse valve
4
Pressure sensor mounted on the right side of the pulse valve
Gasket ring pressure sensor
IMPORTANT
The Viton - gasket and the gasket ring, article number F490013 have to be mounted before
the actual installation!
Heating Plate
The installation of a heating plate is also factory-made. Its position can optionally be on the left or on the right
side. For further information please refer to the Description
“Heating and Accessories“.
Pos.
Description
5
Heating plate mounted on the left side of the pulse valve
6
Heating plate mounted on the right side of the pulse valve
5
6
2
3
4
1