1. DL manuals
  2. WALTHER PILOT
  3. Paint Sprayer
  4. PILOT
  5. Operating Manual

WALTHER PILOT PILOT Operating Manual

Manual is about: Extrusion Gun (350 bar)

Summary of PILOT

  • Page 1

    Das walther pilot-programm • hand-spritzpistolen • automatik-spritzpistolen • niederdruck-spritzpistolen (system hvlp) • zweikomponenten-spritzpistolen • pulverbeschichtungs-systeme • materialdruckbehälter • drucklose behälter • rührwerk-systeme • airless-geräte und flüssigkeitspumpen • materialumla...

  • Page 2

    13 14 15 16 17 18 19 20 21 1 2 3 4 5 6 7 8 9 10 11 12 v 10 250 19 000 v 10 250 22 000 v 10 250 13 000 v 10 250 21 000 v 10 250 02 000 v 10 250 10 000 v 10 250 03 000 v 10 250 14 000 v 10 250 15 0sp v 10 250 15 000 v 10 250 17 000 v 10 250 16 000 v 10 250 11 000 v 10 250 12 000 v 10 250 24 000 v 10 2...

  • Page 3

    Ec declaration of conformity we, the equipment manufacturer, declare under our sole responsibility that the product in the description below corresponds to the relevant basic safety and health requirements. Any unauthorized modifications are made to the equipment or improper use of this declaration ...

  • Page 4

    1 1.1 general model identification models: pilot extrusion gun (350 bar) type: part.-nr. V 10 250 00 000 v 10 250 40 000 (teflon ® - coated) manufacturer: walther spritz-und lackiersysteme gmbh kärntner str. 18-30 d-42327 wuppertal tel.: 0202 / 787-0 • fax: 0202 / 787-217 www.Walther-pilot.De • emai...

  • Page 5

    3.2 general applicable safety precautions all applicable accident prevention rules and regulations as well as other recognized industrial safety and health rules and regulations must be observed at all times use the spray gun only in well-ventilated rooms. Fires, naked light and smoking are strictly...

  • Page 6

    Shut-down 1. Release the trigger lever fully and screw in the safety button (back bushing item 18) until it stops. 2. Turn off material supply to the pump. 3. Place the trigger guard item 10 firmly to a grounded metal pail, turn on the safety button and pull the trigger lever to relieve the pressure...

  • Page 7

    5.5 retooling extrusion gun warning turn off pressure retooling the extrusion gun from the system and check the gauge, otherwise there is a risk of injury. Warning disconnect all supply lines before retrofitting any supply of material to the extrusion gun-injury. Notice to carry out the operations l...

  • Page 8

    To clean the extrusion gun cleaning solutions that are specified by the manufacturer of the extrusion material and do not contain the following ingredients: • halogenated hydrocarbons (eg 1,1,1, trichloroethane, methylene chloride, etc.) • acids and acidic detergents • regenerated solvents (so-calle...

  • Page 9

    8 troubleshooting and solutions warning make sure the entire extrusion system is depressurized before servicing. Warning prior to any repair material supply must be shut off - risk of injury. 9 disposal the costs incurred in cleaning and maintenance materials should be disposed of in accordance with...