WANDERS BORDEAUX Installation And Operation Instructions Manual

Other manuals for BORDEAUX: User Manual

Summary of BORDEAUX

  • Page 1

    1 installatie en bedieningsvoorschriften voor: installation and operation instructions for: bordeaux www.Wanders.Com nl gb.

  • Page 2: Manual Gb Page 17

    2 inhoudsopgave 1.0 technische aanwijzingen voor installateur 2.0 installatie voorschriften 2.1 technische aanwijzingen 2.1.1 schoorsteen 2.2 installeren van de kachel 2.3 aansluiten van de schoorsteen 2.4 aansluiting van de gasleiding 2.5 onderhoud 2.6 ttb 2.7 houtset 2.8 afstandsbediening 2.9 gebr...

  • Page 3

    3 1.Technische aanwijzingen voor installateur belangrijk voordat u de gashaard plaatst en in gebruik neemt, is het zaak deze instructies zorgvuldig te lezen. Bewaar ze!!! Bij de constructie van onze kachels hebben wij niet alleen de grootste aandacht besteed aan uitvoering en uiterlijk, maar ook aan...

  • Page 4

    4 2.2 installeren van de kachel . Verwijder de verpakking. 1 verwijder de twee schroeven achter de bedieningsdeur (zie fig. 1) en het glasraam eraf beuren. 2 verwijder de vier schroeven van de sierlijst en de sierlijst wegnemen (zie fig. 2) 3 verwijder de twee schroeven van het schoorsteen aansluits...

  • Page 5

    5 2.3 aansluiten van de schoorsteen. De gashaard is standaard voorzien van een open trekonderbreker met valwindafleider. Gebruik voor de verbinding vanaf het toestel tot schoorsteenkanaal corrosievast materiaal. De binnendiameter van de pijp moet minimaal 100mm zijn. De aansluiting van het toestel o...

  • Page 6

    6 fig. 4a fig. 4b fig. 4c.

  • Page 7

    7 2.8 afstandsbediening. Plaats de ontvanger van de afstandsbediening links onderin het toestel voordat u de sierlijst plaatst ( fig. 6 ). Schuif de kabel tussen de buitenmantel en de bodem plaat van de verbrandingskamer. Fig. 6 ontvanger led kabel aansluiting motor stekkers voor micro schakela ar s...

  • Page 8

    8 2.9 gebruiks aanwijzing afstands bediening. Instellen van de display (van f/12h naar c/24h en omgekeerd) na het plaatsen van de batterij (9v alkaline) of door het te gelijktijdig indrukken van de knoppen auto en timer begint de aanduiding te knipperen tijdens het knipperen van de display kan men o...

  • Page 9

    9 timer (timer) als de timer modus is ingeschakeld is de temperatuur regeling hetzelfde als in de auto modus tijdens de uitschakel tijden schakelt de motor hel toestel op waakvlam. Ter controle van de ingestelde temperatuur auto indrukken en aansluitend in de timer modus terugkeren. Tijdens de uitsc...

  • Page 10

    10 3.0 gebruikers handleiding in het midden van het toestel achter de klep bevinden zich de bedieningsknoppen van de kachel. Knop a knop b 3.1 in gebruik stellen van de kachel. Open de gaskraan welke in de gastoevoerleiding naar de gaskachel is gemonteerd. Draai de ontstekingsknop - a - rechtsom in ...

  • Page 11

    11 knop e knop d 3.3 buitenwerking stellen van de waakvlam. . Door de ontstekingsknop - a - licht in te drukken en verder rechtsom te draaien schakelt u de waakvlam uit. 3.4 voorschriften voor de gebruiker. Plaats geen brandbare voorwerpen voor, of onderin de gashaard.. Als de gashaard is uitgegaan ...

  • Page 12

    12 3.5 ttb beveiliging de kachel is voorzien van een thermische terugslag beveiliging ( ttb ) dit is een temperatuur schakelaar die in werking treedt als het afvoerkanaal onvoldoende trek heeft zodat de rookgassen in het vertrek komen, als dit het geval is zal het toestel uitslaan. De ttb mag nooit ...

  • Page 13

    13 a b c d e f g h 1 nl g25 i2l 25 4,3 16 380 1.4 0,501 2 be g20/g25 i2e+ 20/25 4,3 16 320 1.4 0,445 3 fr g20/g25 i2e+ 20 4,3 16 320 1.4 0,445 4 it g20 i2h 20 4,3 16 320 1.4 0,445 5 de g20 i2ell 20 4,3 16 320 1.4 0,445 6 at g20 i2h 20 4,3 16 320 1.4 0,445 7 gb g20 i2h 20 4,3 16 320 1.4 0,445 8 pt g2...

  • Page 14

    14 garantie bepalingen wanders metaalproducten b.V. Te netterden garandeert gedurende 1 jaar na aankoopdatum de goede werking van de gashaard, mits het toestel vakkundig is geïnstalleerd en gebruikt volgens de gestelde aanwijzingen. De garantie omvat alle gebreken die te herleiden zijn tot construct...

  • Page 15

    15 branderset buitenmantel schuifplaat glasraam sierlijst verbrandingskamer.

  • Page 16

    16.

  • Page 17: Bordeaux

    17 installation and operation instructions for : bordeaux gas inset stove.

  • Page 18

    18 may we take this opportunity to thank you for purchasing one of our products. While we are constructing our fires, we do not only pay the greatest attention to design and appearance, but also to maximizing user-friendliness and reliability. We are therefore fully confident that you will enjoy thi...

  • Page 19

    19 natural gas (n.G.) natural gas (n.G.) g20 i2h a: country g.B. B: type of gas g20 i2h c: input 4.3kw d: output (max) 3.5kw e: output (min) 2.7kw f: efficiency 81% (nett) g: pressure. (standing) 20mbar h: pressure (operating) 16mbar i: consumption (max) 0.445m3/hr j: nozzle code no. 320 k: low flam...

  • Page 20

    20 1. Technical instructions for fitter important it is important to read these instructions before you install the fire. After commissioning the installation, go through the operation of the unit with the customer and leave these instructions with them. Make sure that they store these instructions ...

  • Page 21

    21 2.2 chimney requirements when an appliance has previously been connected to the chimney, the chimney must be cleaned by a professional. Although a gas fireplace can operate well on a little chimney draw, we advise you to have the chimney checked for soundness and correct operation annually. An ap...

  • Page 22

    22 3. Remove the two screws of the flue adaptor and slide it out of the rails. (fig. 3) 4. If the chimney is to be lined with a flexible liner, secure this to the flue adaptor using proprietary heat proof sealant. Additional securing may be necessary. 5. Now place the fireplace in the recess and sli...

  • Page 23

    23 2.7 ttb this apparatus is equipped with ttb safety mechanism, this shuts off the gas supply to the burner when the chimney is blocked. If this is the case, the apparatus will shut down. When this happens, it is usually an indication of a problem with the chimney. If this is found to be o.K. Then ...

  • Page 24

    24 2.9 fitting the log set • the ceramics vary depending on whether the fire is set to run on natural gas or l.P.G. • refer to the pictures on the next pages to assist correct positioning of the ceramics. • take great care when handling the ceramic logs as they are very fragile. • refer to the diagr...

  • Page 25

    25 fig. 4b fig 4c log layout for natural gas fig. 4a fig 4b fig 4a.

  • Page 26: 3.0

    26 3.0 user instructions 3.1 positioning the remote control receiver. Place the remote control receiver in the bottom left corner of the unit before you mount the decorative frame (check fig. 6). Slide the cable between the outer casing and the bottom of the combustion chamber. (check fig. 6). 3.2 r...

  • Page 27

    27 3.3 remote control operating instructions higher the two large buttons on the remote control hand-set are used to operate the main burner. Auto the two smaller buttons are for auto and timer. Timer instructions for their use follow. Lower setting the display after fitting the batteries in the rec...

  • Page 28: Manual Mode

    28 manual mode adjusting the height of the flames manually, once the pilot has been lit. • press ( higher ) to start the fire or to make the flames higher. Press ( lower ) to make the flames smaller or to switch the fire to the pilot on position. On pressing these buttons, the “send” sign will appea...

  • Page 29

    29 3.4 operating the fire for the first time in the middle of the apparatus, below the main glass there is a drop down door that hides the main controls. (shown below) 1. Open the gas tap which is mounted in the gas pipe leading to the fireplace. 2. Turn the ignition button (a) clockwise, all the wa...

  • Page 30

    30 3.6 user guidelines. • do not use the fire until an authorised fitter has commissioned the unit and carried out the required safety tests. • the ttb fitted to this appliance is not a substitute for an independently fitted carbon monoxide detector. • do not place any combustible objects within 1me...

  • Page 31

    31 exploded view of stove components flue adaptor outer casing combustion chamber burner assembly decorative frame glass window.

  • Page 32: Technical Drawing

    32 technical drawing 14.

  • Page 33

    33 annual service record installation date of appliance: 1st year service completion date: service engineer: . Company name: . Company address: . Postcode: contact number 2nd year service completion date: service engineer: . Company name: . Company address: . Postcode: 3rd year service completion da...

  • Page 34

    34 stove installation specification & information this section to be completed and signed by the installation engineer type gas supply (please tick) natural (mains) gas _______lpg supply in bulk_______ lpg supply in cylinder________ size of governor setting: (i.E.) natural gas 20mbar. Lpg 37mbar) le...

  • Page 35: Guarantee

    35 guarantee dear customer, your gas fire, when installed in accordance with the installation instructions and operated in accordance with these instructions, should provide many years of safe and efficient operation. We thank you for purchasing our product and trust it will provide excellent servic...

  • Page 36

    36 ink.00.7066 wanders metaalproducten b.V. Amtweg 4 7077 al netterden (nl) tel. +31 (0)315-386414 fax +31 (0)315-386201 e-mail: info@wanders.Nl www.Wanders.Com.