WangYe WY50QT-55 User Manual

Summary of WY50QT-55

  • Page 1

    User’s manual :wy50qt-55 preface thank you for buying wangye’s model wy50qt-55 motorcycle, meanwhile, welcome you to join the ranks that wangye motorcycle drives sincerely. Unless it enjoy it is the safer for driving result happy, before driving should first contained every content in manual familia...

  • Page 2

    Tools, then the special agencies of all parts can offer the accessories catalogue and traditional accessories, help you to do a god job in multiple maintaining and repair work. Operation instructions this adjust model wy50qt-55 correct working technique with simple maintenance of motorcycle method, ...

  • Page 3

    List i. Motorcycle safe drive rules for safe drive………………………1 the payload………………………………2 ii. The parts &subassemblies and use instruction parts & subassemblies………………………3 speedometer and indicator…………………5 ignition switch………………………………6 fuel meter…………………………………7 light switch…………………………7 starter switch…………………...

  • Page 4

    - 2 - the payload ※ admonition: only put light goods in sundry box or other deposited place. The goods weight conforms to the following blank 1: blank.1 deposited weight(kg) rack 5kg luggage box 1kg ※ the motorcycle max payload is 75kg,including the weight with the driver and the goods. ※ if the mot...

  • Page 5

    - 4 - fig.1 - 5 - broken line(……)indicate the invisible parts. Fig.2.

  • Page 6

    - 6 - instrument and turn signal light (fig3) (1)left turning signal light ⑵odometer ⑶ fuel meter ⑷ speedometer ⑸ right turning signal light ⑹ high-beam indicator ignition switch(fig4) ⑴on ( )-when the switch turn to this position, start engine and do not pull out the key. ⑵off ( ) when the switch t...

  • Page 7

    - 8 - fig.9 horn switch 3: (fig 7) press (3) button, the horn makes sound. Steering lock (fig8, fig 9): turn handle left to end, presses down ignition key1 to ( ), the steering device are locked do the above opposite it opened. Seat lock(fig 10) put the key into 2 and then anticlock-wise to open the...

  • Page 8

    - 10 - inspection engine oil level(fig 12、fig 13) 1.Keep the motor steady in the plane screw up the oil dip rod and clean it, then reinsert and inspect oil. 2.If the oil level reach to down limit sign (2), replenish the standard oil to upper limit sign (3) suggestion the engine oil type: sae-15w/40 ...

  • Page 9

    - 12 - brake machinery’s burst indicate mark (fig 16) (1). Reference marks. (2). Indicate marks. Notice :if totally brake. Change the brake block when reference marks and indicate marks must be situated a straight line. - 13 - tire check the tire pressure regularly and adjust. Check before the tire ...

  • Page 10

    - 14 - riding motor: warning: wear the trousers to avoid touching with exhaust pipe and was burnt. The entire device must be installed according to requirement of the traffic rule. Take the license to riding. Notice: control the speed and load during 1000km of running in period. Load should be withi...

  • Page 11

    - 16 - engine powered off(fig18, fig19) close oil: revolve to the lowest place according to picture. (normal situation is loose the throttle grip, and the engine is idling speed) put the key to “( ) ” stop operation: when the motorcycle stops, turn the key to “ ” position .Put down the side stand an...

  • Page 12

    - 18 - 1 4 8 12 every month 6 12 18 ref page ﹡ fuel pipe line i i i i ﹡ operation of throttle i i i i 16 ﹡ core of the air note1 c/1000km, if need: r 23 ﹡ spark plug c/2000km,if need: r 27 ﹡ idle, carburetor i i i i 25 ﹡ belt, drive per1000km i if need: r ﹡ oil, gear box note3 (300km)r i 26 system, ...

  • Page 13

    - 20 - trouble phenomenon trouble reason solution the octane value of the fuel is too low change flue oil path stop up clean oil path ignition time is too early or too late check wire and change cdi spark too weak or flameout check ignition and clear out mixed air too dense or race clean adjust carb...

  • Page 14

    - 22 - warm up few minutes after the engine starts idle to adjust screw (1) is it is it improve idle speed slightly to enter to fasten, is it is it withdraw it than screw slowly after stocking to fasten to mix and then rapidly, to stabilizing the position at most, then withdraw slowly, get and stabi...

  • Page 15

    - 24 - changing of gear oil (fig.25) the recommended engine oil: sae 80w/90 oil capacity resolving capacity: 0. 11l changing capacity: 0. 1l • park in main stand。 • take apart the limiting bolt (2), and the spilling bolt (1). Notice: the engine must be warmed up when spilling and the vehicle must be...

  • Page 16

    - 26 - warning: gasoline is inflammable and may cause fire and even explosion under certain conditions. Therefore, do not smoke, make fire or have any fire left behind on draining off fuel. 3. Take out the spark plug, pour about 15~20ml clean engine oil into the cylinder, step down the kick lever re...

  • Page 17

    - 28 - vi . Main technique parameter blank.5 model data model data exterior size mm 1755×670×1170 front wheel 3.00-10 wheelbase mm 1240 rear wheel 3.00-10 ground clearance mm 95 air pressure of f wheel kpa 200 dry weight kg 92 air pressure of r wheel kpa 250 max payload kg 150kg transmission type cv...

  • Page 18

    - 30 - vii. Circuit - 31 - viii. Emission control system warranty statement wangye usa co., llc is pleased to explain the emission control system warranty on highway motorcycle. New highway motorcycle must be designed, built and equipped to regulations and standards of the united states environmenta...

  • Page 19

    - 32 - (i). Ensure that the motorcycle is properly operated, maintained and stored as specified in the owner’s manual; (ii). Give notice to dealer approved by wangye usa co., llc or other qualified service facility of any and all apparent defects immediately upon discovery, and make the entire motor...