WangYe WY50QT-7A User Manual - page 9
- 13 -
Tire
Check the tire pressure regularly and adjust.
•
Check before the tire cooled
•
Check if there any metal trash or gravel in the groove of tires
•
Inspect whether there is nick, embed nail or other tartness object on the tread or not. Inspect
whether there is impress, dent or distortion for rim or not. If find any damaged, should invite
service department to inspect for you.
•
When the tire pattern wear and tear to the wear sign, must change the new tire.
WARNING:
•
If the tire pressure dose not accord with the standard, it will properly cause the traffic
accident. If the tire pressure is too low, the tire will fetch away or take of rim.
Ÿ
It is dangerous that use the worn tire; It will have effect to friction between tire and rode.
Maybe difficult to drive or accident.
- 14 -
Starting engine
(Fig 19)
•
Preparative before starting:Set up the Main Stand,
Put thekey into ignition switch and turn to
“ .
•
Electric starter:Press start button (1) to start engine, DO not
use the starter more than 5 seconds each time.
NOTICE:
Electric starting is only in the condition of grasping the brake handle.
Electric starting not succeed, if starting again with it, we must stop for 30 seconds, If still
can
’t start, Please use kick-start.
Engine kick-start :open ignition switch and add gasoline slowly, step kick-starter pedal
down quickly with strength to start engine.
Notice: After using kick-starter pedal, pull it back to original position. Otherwise
have effect to safety ride, and bad to engine.
Had better not open ignition switch when scooter has not use for a long time, and first
step kick starter for some times. Make flue into carburetor and then into cylinder, and
open ignition switch, Start engine, it is easy to start engine like this.
If cold start warm up engine for 3 minutes.
Fig19