WANHAO DUPLICATOR 7 User Manual - Congratulations

Congratulations

You  have  just  purchased  a  new  type  of  3D  printer  using  Direct  UV-­light  Printing  (DUP)  

technology.  This  is  a  newly  applied-­for  method  of  LCD  image  creation  allow  controlled  UV  

light  get  through  the  LCD  screen  which  hardens  liquid  with  the  light  from  an  UV  light  source.  

This  revolutionary  system  is  a  new  way  of  printing  that  uses  normal  UV  light  as  the  energy  

providing  source  to  initiate  the  free  radical  polymerisation  necessary  to  change  the  liquid  

imagepac  resin  into  your  hardened  object.

The  principle  behind  your  printer

There  are  two  surprising  advantages  of  this  new  DUP  technology:

i)      We  can  use  high  resolution  low  cost  LCD  screens  that  are  widely  available  as  monitors,  

tablets,  mobile  phone  and  televisions  providing  phenomenal  value  for  money,  which  we  

pass  directly  onto  you.

ii)      The  energy  used  by  Duplicator  7  printers  is  again  an  order  of  magnitude  lower  than  

used  in  comparable  systems.  This  is  good  for  your  energy  bills  and  the  ecology,  but  there  

is  a  huge  performance  advantage  in  that  there  is  no  unnecessary  energy  created.  All  of  the  

available  photons  strike  photoinitiators  and  hand  over  their  energy.  In  comparable  Digital  

Light  Projector  and  laser  systems  there  is  a  lot  of  excess  energy  which  can  lead  to  over-­cure.

Safety  Information

Read  the  instructions  carefully.  Keep  this  document  for  future  reference.  Follow  all  warnings  

and  instructions  marked  on  the  product.

Observe  the  following  guidelines  when  connecting  and  disconnecting  power  to  the  external  

power  supply  unit:

-­      Install  the  power  supply  unit  before  connecting  the  power  cord  to  the  AC  power      outlet.

-­      Unplug  the  power  cord  before  removing  the  power  supply  unit  from  the  printer.

-­      This  machine  is  very  quiet  in  operation.

˚ŷƼsNjǼsŸŘǼEĶsŸNjʪǼʰǣǼEĶsǣȖNj¯OsʰsŘǣȖNjÞضǼÌǼǼÌsŎOÌÞŘsOŘŘŸǼ¯ĶĶŘ_Þǣ

level.

-­      Do  not  operate  outdoors.

-­      Do  not  allow  resin  or  any  liquids  to  get  inside  the  chassis,  wipe  up  any  liquid  spills  

immediately.

-­      Store  the  printer  in  its  original  packaging  when  not  in  use.

-­    Disconnect  the  printer  from  AC  before  storage  or  when  not  used  for  a  long  period  of  time.

AFTER  SALES  SUPPORT

86-­571-­23290996

support@wanhao3dprinter.com

Model  :  Duplicator  7

5