Warbird Messerschmitt Bf 109F-2 Assembly Manual - page 16
Assembly Manual for Messerschmitt Bf 109F-2
Copyright 2005 Thomas A. Jacoby and WarbirdKits.com
- 16 -
Using the template provided, cut a paper canopy and
fit it to the model. When satisfied with the fit,
transfer the pattern to the clear plastic sheet. Cut
out the clear plastic canopy and glue it in place.
Add the desired scale details, such as exhausts, air
scoop, etc.
Details on how to make a scale spinner are included
at the end of this manual. This model needs a
rounded spinner – the commercially-available
“pointy” spinners just don’t look right!
Finishing Your Model
We suggest covering the entire model (except the
canopy) with 1/2-ounce glass cloth and finishing
resin for maximum strength.
Apply a light coat of primer – just enough to fill the
weave of the glass – and sand most of it off.
Paint and decorate the model as desired. See the
attached 3-view for details on markings and panel
lines.
Finally, seal the entire model with a coat of Krylon
Satin Crystal Clear.
Decals
CAUTION: You must seal the decals before immersing
them in water!
The decals included in this kit are printed with Epson
DuraBrite™ inks on the best inkjet water-slide decal paper
available. Follow the steps below to achieve a great looking
set of markings on your Friedrich.
Seal the decals with several thin coats of Krylon
Crystal Clear™ spray varnish. Make sure you
thoroughly cover the ink; this will prevent smears
and stains during everyday handling.
Make sure the surface where the decal is to be
applied is smooth and glossy. Matte surfaces will
permit tiny air bubbles to be trapped between the
surface and the decal, thus spoiling the decal.