WarbirdKits T-34A Mentor Assembly Manual - page 16
Assembly Manual for T-34A/B
Copyright 2008 Thomas A. Jacoby and WarbirdKits.com
16
Push a pin through the cardboard templates and the
cowl as shown.
Attach the cowl to the fuselage using small screws.
Tail Surfaces
Cover the fin, rudder, stabilizer and elevators as
desired.
Hinge the elevators to the stabilizer.
Glue the stabilizer assembly in place on the fuselage.
Glue the fin in place on the stabilizer.
Flying Setup
The T-34 should balance at the point shown on the
plan: approximately 2-
5/16” from the wing leading edge
at the center. For the first few flights, you may want to
move the balance point slightly forward.
Set the high-rate control throws to:
Elevator: 1/2” up – 1/2” down
Ailerons: 3/8” up – 1/4” down
HELP!
If you have questions or need help with assembly of the kit,
drop an email to
tom@warbirdkits.com
.