Warbirds WB348TS Installation Instructions Manual

Summary of WB348TS

  • Page 1

    P.O. Box 1037 650 s. Royal lane, suite 100 coppell, tx 75019 (800) 486-4892 8:00 to 5:00 cst (central standard time) toll free fax: (877) 304-1728 email: customerservice@craftmade.Com www.Craftmade.Com ® better by design p. O. Box 1037 650 s. Royal lane, suite 100 coppell, tx 75019 ee.Uu. (800) 486-...

  • Page 2

    Read and save these safety precautions 1. Turn off electricity at main switch before wiring or servicing fan in order to avoid possible electrical shock. 2. All wiring must be in accordance with the national electric code (ansi/nfpa 70-1999) and local electrical codes. Electrical installation should...

  • Page 3

    What you have/componentes incluidos parts quantity piezas cantidad 1. Mounting plate 1 placa del soporte 1 2. Fan motor/ outer housing 1 motor del ventilador/ caja exterior 1 3. Globe 1 esfera 1 4. Blades 4 aspas 4 tiger shark model 3 modelo tiger shark 3 5. Balance kit 1 juego de equilibrio 1 1 2 s...

  • Page 4

    Step 3 / paso 3 secure mounting plate (#1) using screws and washers (s2) directly to the outlet box. Arrows on mounting plate and fan body inner housing plate will line up (see step #6). Be sure to position arrow on mounting plate in the direction that the cowling on the fan body should face. If not...

  • Page 5

    5 step 5 / paso 5 1. Connect fan wires to ceiling wires: white fan wire to white outlet wire, black to black and green to green. Wire connectors (s5) are provided for your convenience. If an additional blue wire is present then also connect the blue wire to the black wire. (optional light kit may be...

  • Page 6

    6 step 6 / paso 6 line up arrow on mounting plate (#1) to arrow on fan body inner housing plate (#2). Push outer housing (#2) up and twist clockwise approximately 1/2". Outer housing unit will set in mounting bracket. Secure with outer housing screws (s2). Alinee la flecha de la placa de soporte (#1...

  • Page 7

    Operation instructions / instrucciones de uso 1. The sequence of operation for the motor pull/chain switch is off- hi-med-low. 2. Push the slide switch right for forward, and left for reverse action of the blades. 3. The pull chain switch for the uplights and side body lighting in the body of the fa...

  • Page 8

    Common problems problem a: fan will not start remedies: 1. Check fuse or circuit breaker and replace if necessary 2. Check that pull chain switch is on and that slide switch is up or down. 3. Turn off electrical power and check all wire connectors. Problem b: fan is excessively noisy remedies: 1. Ch...