Summary of KS80
Page 1
Professional knife sharpener for your safety and continued enjoyment of this product, always read the instruction book carefully before using. Ks80
Page 2: Contents
Contents important safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 instructions for use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 important safeguards when using electri...
Page 3: Knives With Extreme Care.
10. The use of attachments not recommended or sold by waring pro ™ may cause fire, electric shock, or injury. 11. Do not place near a hot gas or electric burner or heated oven. 12. Do not attempt to sharpen scissors, ax blades or any other blade that does not fit freely in the slots. 13. Do not let ...
Page 4: Notice
Notice this appliance has a polarized plug (one prong is wider than the other). To reduce the risk of electric shock, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. ...
Page 5: For Best Results
The lightning flash within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of fire or electric shock to persons. The exclamation point within an equilatera...
Page 6: Parts
Parts 1. Coarse grinding station 2. Fine grinding station 3. Stropping/polishing station 4. Blade guide wheels 5. Removable magnetized drawer (not shown) 6. On/off switch 7. Suction cup feet 8. Power cord 5 1. 3. 4. 6. 5. 2. 7. 8. Typical kitchen knife bolster tip edge handle heel.
Page 7: Instructions For Use
Resetting thermal protection your waring pro ™ knife sharpener is equipped with a thermal protection device to protect the motor from overheating. If the unit stops running under heavy use, turn the power switch off and unplug the power cord. Allow approximately 10 minutes for the motor to cool down...
Page 8
Without twisting. Maintain uniform contact on the blade. If the knife is curved lift the handle up as the knife tip approaches the end of the slot, keeping constant pressure on the blade contour. Sharpen the entire blade. An eight- (8) inch blade should take about 4–5 seconds per pull. Pull shorter ...
Page 9: Cleaning And Maintenance
Additional pulls in the strop/polish station will hone the edge even further. Procedure for sharpening serrated blades all types of serrated blades can be sharpened with the waring pro™ professional knife sharpener. Use only step 3 (strop/polish) when sharpening a serrated blade. This will sharpen t...
Page 10
Metal dust will slowly accumulate below the coarse and fine grinding wheels. A removable drawer can be found underneath the grinding wheels in the rear of the unit. Occasionally, remove the drawer and wipe with a damp cloth or paper towel. This will remove all of the metal shavings. Replace drawer. ...
Page 11
10
Page 12
© 2008 waring waring products division of conair corporation 150 milford road east windsor, nj 08520 www.Waringproducts.Com printed in china ks80 ib 08wr199 ib-5939.