Warm House EH0221 Instruction Manual

Manual is about: Arched Glass Electric Fireplace

Summary of EH0221

  • Page 1

    Please read these instructions thoroughly before use and retain for future reference. Instruction manual eh0221 arched glass electric fireplace.

  • Page 2

    Important safety instructions when using this electrical appliance, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to person, including the following: this appliance must be used on an ac supply only and the voltage marked on the heater must correspond to...

  • Page 3: Getting Started

    Do not cut off bracket or change shape of the bracket. Do not use the appliance in the immediate surroundings of a shower, bath or a swimming pool. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. Wa...

  • Page 4: Installation

    006 007 008 009 010 011 012 013 005 004 003 002 001 figure a helpful advice before fitting please retain all packaging until you have checked and counted all the parts and the contents of the fixing pack against the parts list. The fixing pack contains small items which should be kept away from youn...

  • Page 5

    This appliance is designed to be permanently fixed to a wall at a minimum height of 600mm. The wall bracket must be fitted horizontally and the cable routed to the bottom right of the heater. A height of 600mm from bottom of heater to floor is recommended for optimum viewing of fuel bed see fig.1 fo...

  • Page 6: Fitting The Feet

    Fitting the feet the box contains two plastic feet and four screws for each foot. Place the fireplace on a flat, stable surface with the back of the fireplace resting on the surface. Push the feet onto the base of the fireplace and fit the screws in place. Stand the fireplace up and ensure that it i...

  • Page 7: Instructions For Use

    Instructions for use the fireplace can be operated either by the switches (located on the top right hand side of the fireplace) or by the supplied remote control. Manual operation the switches are located at the top right hand side of the fireplace. The standby switch must be switched on first. Pres...

  • Page 8: Troubleshooting

    Troubleshooting symptom solution no operation/no fan. Check the fuse in the plug. Replace if necessary. The safety cut-off may have operated. Please allow it to cool down for 15 minutes, then switch it back on. No fire effect light. Check if the led’s are working. Cleaning warning: always disconnect...

  • Page 9: Distributed By:

    The crossed out wheelie bin symbol on this item indicates that this appliance needs to be disposed of in an environmentally friendly way when it becomes of no further use or has worn out. Contact your local authority for details of where to take the item for recycling. Distributed by: rite aid, 30 h...