Warmington SG 1100 Installation Insrtuctions - page 15
14 June 2016
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm……..Copyright ©
15
OPERATION OF YOUR E.G GAS BURNER IGNITER ONLY
AS SHOWEN FROM THE FRONT OF THE BURNER.
Note : Flueless Outdoor fires do not have a Fan Option:
This Control Panel is Located on the Bottom Left Hand Side of your Warmington decorative Gas Fire.
Press and Release the Power Button. This will Start the Electronic Spark and the Power LED will be on Perma-
nently . The Pilot will Ignite First, once this is on, it will ignite the Main Burner. Pressing and Releasing the Power
Button again will Switch Off the Appliance.
When the Appliance is Turned On again, the Gas Fire will resume the previous Flame and Fan settings , unless the
Appliance was Switched Off due to Power Failure. In the circumstance of a Power Failure the Remote Control
System will return to the default settings which is a Low Flame and the Fan Turned Off.
If the Gas Fails to light, the Appliance it will go into Lock Out Mode , after trying to ignite for 1 minute (approx.) . In
Lock Out Mode the Power LED will remain illuminated. To start the Appliance again Press and Release the Power
Button Twice after the Gas Supply Resumes.
Press and Hold the + button to Increase the Main Burner Flame . Press and Hold the - button to Decrease the Main
Burner Flame. By holding the + or - Flame Button for up to 10-15 sec this will Increase or Decrease the Main
Burner Flame to it’s Max or Min .
FOR MANUAL OPERATION OF YOUR EG WARMINGTON DECORATIVE FIRE
FLAME OPERATION
Important Note:
Fire for Outdoor use only, NOT to be Installed Indoors .
* Note : Ensure that all Electronic Equipment on the EG Fire Range is protected from
the Weather , Damage may occur when Electronics become in Contact with Mois-
ture &/or any Water .